Instruction for Use

ManualsBrandsWhirlpool ManualsDishwashersGSXK 5010

5019 496 01154

Before using the dishwasher, read the installation and maintenance instructions carefully!

GSXK 5010

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example,

according to different loads, extra functions, different settings, water supply temperatures, water hardness and

power supply voltage.

2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:

for detailed

information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

3) The antibacterial action has been proven in collaboration with the Pasteur Institute of Lille (France), in conformity

with. Standard NF EN 13697 of November 2001.

1. OVERVIEW

Programme selection button

Press the button (repeatedly) until the indicator lamp

of the desired programme lights up (see table 1.1).

At the end of the wash cycle, the last programme

selected is memorized.

Half Load/Multizone

Half load cycle can be used for the upper or lower

rack. Select the programme then press the “Half load”

button. The indicator lights up, and goes off at the end

of the programme. This function can be used with the

programmes indicated in table 1.1. At the end of the

programme, the most recently selected setting

remains memorised.

Detergent setting upon initial use and when using a

different type of detergent

Indicator lamp off = Powder/gel detergent (factory setting).

If using combined detergents, press and hold the

button for 3 seconds; the indicator lamp lights up =

rinse aid and salt indicators are deactivated.

From water hardness level 5, the salt indicator remains

active. At the end of the programme, the most

recently selected setting remains memorised.

Delayed Start button

Press the button repeatedly to delay the start of the

programme by 2, 4 or 8 hours. Then press the

Start/Resume button. The remaining time is

indicated by the corresponding indicator lamp. The

wash programme will start after the set time. The

set delay will be memorised at the end of the cycle,

and can be selected by pressing the button again.

Start/Resume button

The indicator lamp lights up during operation,

flashes when the programme is interrupted before

completion and switches off at the end of the

programme.

Cancel/Off button

Press the button to switch the dishwasher off or to

interrupt the selected programme.

If the Cancel/Off indicator lamp flashes repeatedly, this

indicates a fault: see chapter 5 “What to do if...”.

Salt level indicator and rinse aid level indicator

These light up at the end of the programme if salt

or rinse aid needs topping up.

Only add just before starting a wash cycle.

Table 1.1.

Programme Table

Detergent

dispenser

Consumption

Programmes

Additional

options

Description of

programme

large small Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. — — 4.0 0.03 14 ±

Quickwash 45°C

Lightly soiled crockery, with no

dried-on food.

X — 11.0 0.80 30 ±

Bio Normal

50°C

Normally soiled crockery.

Energy-saving programme.

X X 12.0 1.05 165 ±

Hygienic +

Normally or heavily soiled crockery,

with additional antibacterial wash.

Stopping a programme underway

(e.g. by opening the door) can

compromise the elimination of

bacteria.

X X 13.0 1.50 115 ±

Intensive 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pots and pans.

X X 14.0 1.55 155 ±

Summary of content (8 pages)

PAGE 1
Before using the dishwasher, read the installation and maintenance instructions carefully! GB GSXK 5010 1. OVERVIEW Programme selection button Press the button (repeatedly) until the indicator lamp of the desired programme lights up (see table 1.1). At the end of the wash cycle, the last programme selected is memorized. Half Load/Multizone Half load cycle can be used for the upper or lower rack. Select the programme then press the “Half load” button.
PAGE 2
. QUICK REFERENCE GUIDE Detailed instructions are given on the following pages; also see section “5. What to do if...”. 1. Switch the appliance on The dishwasher switches on automatically when any button is pressed, except for the button. If no button is pressed within 30 seconds, the appliance switches to Energy Saving mode. 2. Select the right type of detergent Depending on the dishwasher model 3. Fill the detergent dispenser 4. Check the rinse aid level 5. Set the water hardness level 6.
PAGE 3
. HOW TO USE THE APPLIANCE HOW TO FILL THE DETERGENT DISPENSER Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer’s recommended dosage. Observe the manufacturer’s safety warnings! Press the left button (button 1) on the dispenser to open the detergent dispenser compartments. a. Powder/gel/tabs Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).
PAGE 4
3. HOW TO USE THE APPLIANCE HOW TO CHECK/FILL/ADJUST SALT Only use regeneration salt specifically intended for dishwashers. a. How to check the salt level Depending on the model, check the visual indicator . The window on the salt reservoir cap is clear when salt needs to be added and coloured when the salt present is sufficient. In the case of appliances with an electric indicator on the control panel, the salt indicator lights up at the end of the wash cycle when salt needs to be added. b.
PAGE 5
3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on model: Adjustable glass holder A Depending on the position, for small glasses or stemware. Crockery holder B Horizontal for: cups/long utensils, in raised position for plates and stemware. Long-handled utensils (kitchen knives) must be arranged with the sharp end facing in towards the appliance. Cutlery basket C It can be placed on the upper rack when the “Half load/Multizone” function is selected and there is no divider inserted.
PAGE 6
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packaging The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher has not been damaged during shipping and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3.
PAGE 7
5. WHAT TO DO IF... If a fault occurs, before contacting the After-Sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes/solutions ...is not working/will not start - The appliance must be switched on. Check the household circuit fuse if there is no power supply. The dishwasher door must be closed.
PAGE 8
5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food residues - ...have deposits: - regeneration salt residue - In the event of frequent use of low temperature programmes (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).