Instruction for Use

5019 496 01118
1
GB
GSXK 7524
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on
the EN comparison test and other tests, contact the following address: “[e-mail]”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.
Standard NF EN 13697 - November 2001.
1. OVERVIEW
ON button
OFF button
Fault indication and wash time display
With “Delayed start” selected it indicates the time
remaining until programme start (hh). Near the end of
the programme, the time remaining in minutes is
displayed during the drying cycle.
In the presence of a fault indication “F..” –, consult
section 5 “What to do, in case of …”.
“Delayed start” button
Press the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
press of the button, the delayed start indicator increases
by one hour and after 24 restarts from 00. Then press
the START button. The dishwasher will start after the set
time.
Programme selection button
Press the button (repeatedly) until the required
programme indicator lights up.
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds to cancel a started
programme and selected extra functions. The main fault
indications (repeated flashing of the START indicator) can
be cancelled by RESETTING. Also refer to section 5
“What to do, if...”.
The acoustic signal continues to sound as long as the
error persists.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable extra
functions
Loading instructions large small Litres kWh Minutes
1
Auto Sensor 50-65°C
Recommended programme for daily
use, with dry food residuals (e.g. EN
50242).
X X 11-16 1.10-1.50 100-130 ±
1)
2
Quickwash 40°C
Lightly soiled crockery, without dry
residuals.
X — 11.0 0.80 30 ±
1)
3
Bio Normal
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 12.0 1.05 165 ±
1)
4
Hygienic +
3)
Normally or heavily soiled crockery,
with additional antibacterial action. An
interruption of the programme (e.g.
due to door opening) can compromise
elimination of germs.
X X 13.0 1.50 115 ±
1)
5
Intensive 70°C
Recommended programme for very
soiled crockery, particularly suitable
for pots and pans.
X X 14.0 1.55 155 ±
1)