Installation guide

ManualsBrandsWhirlpool ManualsRangeOfficial Whirlpool electric range

m m

Tip Over Hazard

A child or adult can tip the range and

be killed.

Connect anti-tip bracket to rear

range foot.

Reconnect the anti-tip bracket, if the

range is moved.

Failure to follow these instructions can

result in death or serious burns to

Quick Reference

TabJe of Contents:

Pages

%-_

[]

9758642

Before tou start

Product dimensions

Cabinet dimensions requirements

Electrical requirements

Installation steps

Check operation

if range does not operate

if you need assistance tservice

Moving the range

children and adults.

www.whN pool.corn

Read and save these instructions.

iMPORTANT:

installer: Leave Installation

instructions with the homeowner.

Homeowner: Keep Installation

instructions for future reference,

Read and save these instructions for

local electrical inspector's use,

Write down the model and serial

numbers before installing range,

Both numbers are listed on the

model/serial rating plate located

on the oven frame behind the

storage drawer panel

Model #

Serial # Part No. 9758642

Summary of content (12 pages)

PAGE 1
m m 9758642 Quick Reference TabJe of Contents: Pages Before tou start Product dimensions Tip Over A child or adult be killed. Connect anti-tip range foot. Cabinet dimensions Hazard can tip the range bracket Reconnect the anti-tip range is moved. Electrical and %-_ to rear bracket, [] requirements Installation steps Check operation if range does not operate if the Failure to follow these instructions result in death or serious burns to children and adults.
PAGE 2
Mobile Before you start... Your safety and the safety others are very important. of We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word 'DANGER" or 'WARNING.
PAGE 3
Product dimensions 30-3/4" (78.1 cm) cooktop width 36" (91.4 cm: cooktop height with bveling legs lowered 1-I/2 turns 1" (2.5 cm). spacer 30" (76.2 cm} width 26-7/8" (68.3 cm} del: handle Cabinet dimensions/requirements Cabinet 25" (63.5 cabinet opening dimensions cm) countertop depth, shown depth, are for: 24" (61.0 crn) base 36" (91.4 ore} countertop _-_-_,_ height I I / _._" _..._..--_ _ i,_ /,_a_learanc u_ deprn wl i(,:e6; 2opm_i_ n,,_idt I 4" (10.2 cmi min.
PAGE 4
Slide@ ranges: countertop preparations Electrical requirements The cooktop sides of the siideqn range fit over the cutout edge of your countertop+ If you have a square finish countertop and the opening 30"" (76+2 cm), no countertop is required+ (fiat) width is preparation Formed front-edged countertops: Must have moiled edge shaved fiat 1/2"' (1+3 cm) from each front corner of opening+ THe countertops may need trim cut back 1/2" (1+3 cm) from each front corner and/or rounded edge flattened, ff connecti
PAGE 5
New start... EJectricaJ Excessive Use two or more install range. Weight people Hazard to move Failure to do so can result other injury. located and in back m Remove shipping materiab, tape and protective film from range. Keep cardboard bottom and shipping base under range+ Remove oven racks and parts package from inside oven+ A child or adult be killed, Connect anti+tip range foot. Hazard can tip the bracket Reconnect the anti+tip range is moved.
PAGE 6
Power suppJy cord method: NOTE: The bag containing three aluminum terminal lugs is not used when connecting the range using a power supply cord. 5_ Use either ring-type terminals spade terminals with upturned to connect the power supply. or ends 6_ Complete electrical connection according to your type electrical supply ("Four-wire electrical connection" or "Three-wire electrical terminal connection[') Four-wire electricaJ 10.
PAGE 7
Direct wire method: Copper NOTE:The bag containing three aluminum terminal lugs must be used when making a direct wire connection. or Aluminum 7. 8. IMPORTANT: wire the aluminum terminal lugs must be assembled terminal posts with the facing out as shown. to the set screws Attach three aluminum to terminal posts. terminal lugs Use a 3/8" nut driver and tighten the nuts securely, Nuts must be tightened to 20 in/Ibs of torque for proper electrical connection. 9.
PAGE 8
Operating position Move chose to cabinet range m Make Remove cardboard • Look for the anti-tip attached to floor. or hardboard from under range. Carefully move range into final position. I sure the anti-tip bracket bracket securely is installed: opening. M Pull drawer open to first • Slide range back so rear is under anti-tip bracket. range Place rack in oven. Place level on rack, first side to side; then front to back foot stop position.
PAGE 9
Check operation 7[] Check the operation cooktop eiements: Push in and turn each surface unit controi knob to "HF' position. Check the operation of the cooktop ebments and indicator Hghts. reaches Press Check the operation of the Look through the oven window.The top element should glow red. Press the "OFF/CANCEL' pa& The bottom element should glow red and the indicator light should be on.The upper element should become hot but not glow red.
PAGE 10
If range does not If you need assistance: If you need service: operate: if you have questions cleaning or maintaining Maintain by calling compan% the quality built into your an authorized service To obtain authorized the name and number service company: [_ Check that the circuit tripped or the house [_ Check plugged [_ that the breaker is not fuse blown. power into the supply cord is [_ Refer to [_ Caii the Customer interaction Center.
PAGE 11
Notes 11