Manual

iNSTALLATiONiNSTRUCTiONS
1, If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to upper
cabinet or rear wall. Slide cardboard or hardboard under
range before moving range across floor to prevent damaging
floor covering. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
or dirt.
2, Determine which venting method (roof or wall venting or
non-venting) you need to use. This range hood is shipped for
non-vented installation.
7" {17,8 cm) round vertica_ vent system
oenterline
I I ,,
8" (20.3 ore) __ 7 F*
i (19_1 cm)
dia_ hole -\ i
wall 5" 1_/4"(3.2 cm) 2"
(122cm) dia.hole (5_1crn)
31/4"X 10" (8,3 X 25,4 cm) horizonta_ vent system
centerline
""..q 1¼" (3.2 cm)
3,
4,
wall W' (3.0 rnrn) 1F,"
pilot holes (3.8 cm)
Hood size A
30" (76,2 cm) 13_%'' (35,4 cm)
36" (91,4 cm) 16_5A6'' (43,0 cm)
Drill four 1/_,,(3.0 mm) pilot holes for hood mounting screws. If
cabinet has recessed bottom, add wood shim strips on each
side.
From the following diagrams, select the diagram for your
installation.
Vented installations: Cut the vent system and electrical wiring
access holes as required.
Non-vented installations: Drill only the 11/4"(3.2 cm) dia. wiring
access hole required.
[] If wiring through the top, use location shown in verticN
vent systems.
[] If wiring through the back, use location shown in
horizontal vent system.
31/g' x 10" {8,3 x 25,4 cm) rectangular vertica_ vent system
5W'
i (19.1 cm)
i
/_ . ! i
Set the hood on a protective covering such as cardboard or a
large towe!. Remove the 7" (17.8 cm) round vent plate from
top of hood. Set vent plate and mounting screws aside.
5" 1 W' wall 1W' (3.2 cm)
2"
(12.7 cm) (32 crn) dia.hole (5_1 crn)
A. 7" (17.8 cm) round vent plate