Instruction for Use

21
en
the connector have clicked.
7. Plug the appliance into the power outlet.
8.Preparethevegetablesorfruitcuttingaatside.
Insert the hook of the spiralizer pusher (S) into the
fooduntilitisrmlyinserted.
Figure 8
9. Insert the spiralizer pusher (S) with vegetables or
fruits in the spiralizer feeding chute. Please be
sure that foods cannot rotate.
10. Rotate the speed-adjusting dial (A) to select
the desired speed. Pressing and holding the
ON/OFF button (B), the attachment starts
choppingimmediately.Formaximumspeedpress
the TURBO button (C) for a short time.
11. To removes scraps, push the release button (T) on
the top side of the spiralizer pusher (S). Scraps
will be ejected and detached.
12. Open the lids to access to the bowl and to
processed foods.
HINTS
• Spiralized vegetables are a low-carb substitutes for
pasta and noodles.
• Firm fruits without seeds or hollow centre will
perform better.
• Select vegetables as straight as possible.
•Fruitslikepearsshouldbemixedwithsomedrops
of lemon juice to prevent browning once the surface
has been cut
• Prepared potatoes and parsnips also discolor in air
ifnotusedimmediatelysotoavoidthisprepare
theseitemsjustbeforeyouwanttoservethem.
• Processed vegetables could be eaten raw or oven
cooked or stir fried.
• You can use the small cone left over to decorate
plates.
3 mm thickness.
The strip blade can cut in noodles or strip with
3mm*3mm thickness.
• Don’t operate hard food for more than 10 seconds
continuously.
To use the spiralizer attachment as a chopper follow
these instructions:
Figure 3
1.Firstofall,makesurethenon-slipring(G)isxed
to the bottom of the bowl (H)
2. Install the bottom lid (I) on the bowl (H).
3. Fit the desired blade (M) (slice or strip) on the pin
intheconesupport(L)–alwaysttheblade
before adding the ingredients. Insert the cone
support (L) into the bottom lid (I).
4. Place and rotate clockwise the upper lid
(N) until blocked in position, as shown in pic.
5.Removethespiralizerpusher(S)andiptheinlet
cover (O) over the spiralizer feeding chute.
6. Assemble the motor unit (D) into the bowl lid until
the two small buttons on the left and on the right of
the connector have clicked.
7. Plug the appliance into the power outlet.
8. Insert vegetables or fruits in the chopper feeding
chute and insert the standard chopper pusher (P).
9. Rotate the speed-adjusting dial (A) to select
the desired speed. Pressing and holding the
ON/OFF button (B), the attachment starts
choppingimmediately.Formaximumspeedpress
the TURBO button (C) for a short time.
10. Open the lids to access to the bowl.
To use the spiralizer attachment as a spiralizer follow
these instructions:
Figure 4
1.Firstofall,makesurethenon-slipring(G)isxed
to the bottom of the bowl (H)
2. Install the bottom lid (I) on the bowl (H).
3. Fit the desired blade (M) (ribbon or noodles) on
thepinintheconesupport(L)–alwaysttheblade
before adding the ingredients. Insert the cone
support (L) into the bottom lid (I).
4. Place and rotate clockwise the upper lid
(N) until blocked in position, as shown in pic.
5.Removethechopperpusher(S)andiptheinlet
cover(O) over the chopper feeding chute.
6. Assemble the motor unit (D) into the bowl lid until
the two small buttons on the left and on the right of