Instruction for Use

14
Precautions and General Recommendations
1. Packing
The packing box may be fully
recycled as confirmed by the
recycling symbol.
2. Energy saving tips
•
Always dry a full load:
depending on the type of
laundry and the programme/
drying time.
•
By preference use the
maximum spin speed allowed
by your washing machine,
since draining the water
mechanically requires less
energy. You will save time
and energy when running
your drying cycle.
•
Do not overdry the laundry.
•
Clean the lint filter after
every
drying cycle.
•
Place your dryer in a room
with a temperature between
15° C and 20° C. In case of
higher temperature ventilate
the room.
•
Always select the correct
programme/drying time for
the load in order to obtain
the desired drying results.
•
Select the
gentle
option only
with small loads.
•
When drying cotton, for
example: dry
iron dry
and
cupboard dry
loads together.
Start with the
iron dry
programme/drying time
setting, remove the laundry
to be ironed at the end of
that cycle and dry the
remainder of the load on the
cupboard dry
setting.
3. Disposing of packaging
and old Dryer.
The dryer is built from
reusable materials. The dryer
must be disposed of in
compliance with local waste
disposal regulations.
•
Before scrapping, cut off the
power cable so that the dryer
cannot be connected to the
mains.
4. Child safety:
Children must not be allowed
to play with the dryer.
5. General
recommendations:
•
Always set the programme/
time selector knob to the “0”
position after use. This
prevents the dryer from being
switched on accidentally.
•
Before cleaning or carrying
out maintenance, switch off
the dryer and disconnect it
from the mains supply.
•
To clean the outside of the
dryer, use a neutral
detergent and a damp cloth.
•
Do not use abrasive
detergents.
•
Wipe away lint from the door
seal and the door using a
damp cloth.
•
If the lint filter mesh is
clogged, clean it with water
and a soft brush.
•
Since lint can go through the
filter it is necessary to clean,
from time to time, the
complete filter area
(including below the filter)
with a brush, a damp cloth or
with a vacuum cleaner.
•
If necessary, the power cable
may be replaced with an
identical one obtained from
our After-Sales Service. The
power cable must only be
replaced by a qualified
technician.
EC Declaration of
Conformity
•
This dryer has been designed,
constructed and distributed in
compliance with the safety
requirements of EC Directives:
•
73/23/EEC Low Voltage
Directive.
•
89/336/EEC EMC Directive.
•
93/68/EEC CE Marking
Directive.
The dryer must only be used
in the household for the
prescribed uses.