HHP7.5CM HHP6.5CM HHP9.5CM HHP6.5CM(WH) HHP6.5CM(BK) HHP7.5SCBI HHP6.
6x Ø 8 x 40 6x Ø 5 x 45 4x Ø 3,5 x 9,5 1x 2 3 4 5 2x ø 150-125mm ø 150mm 1x 1x 2x 2
min.
2 3 = = = x6 = 55 0m 65 m 0 m m 4 5 Ø 8 mm x6 7 5 m m 6 4 x6 x2
8 9 1 2 x2 3 10 11 ø 150 ø 120 x2 12 13 5
14 x2 ø 150 ø 3,5 x 9,5 15 16 17 18 B 6 A
Warnings ! Keep this manual for reference. If you sell, transfer or move the unit to another location, make sure to keep the manual with the product. ! Read the instructions carefully - they contain important installation, user and safety information. ! Do not tamper with the electrical or mechanical equipment of the product or its exhaust ducts.
• Strictly observe all local regulations in relation to the technical and safety measures to be employed in fumes extraction. • Clean the product frequently, inside and out (AT LEAST ONCE A MONTH, and in observance of the maintenance instruction given in this manual). • Failure to observe the hood cleaning and filter cleaning/replacement instructions can result in fires. • Never use the hood without its bulbs properly installed - electrocution hazard.
Installation The installation procedure is illustrated in the first pages of this manual. The installation must be done by a qualified technician. Electrical hook up The mains voltage must match that given on the ratings label inside the hood itself. If the hood has a power plug, connect the hood to an easily accessible regulatory power socket.
GB PYRAMID controls T5 Booster Pressing the button sets the hood to high speed. After 5 minutes, the hood returns to the previous speed; pressing a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. Models with mechanical keypad HHP7.5CM HHP6.5CM HHP9.5CM HHP6.5CM(WH) HHP6.5CM(BK) T1 T2 T3 T6 Lights ON/OFF T4 T5 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. T2 Speed 1 Pressing the button sets the hood to speed 1.
Maintenance and care Replacing the bulbs Disconnect the unit from the mains and remove the grease Caution! Before cleaning or servicing the unit, filter. disconnect it from the mains by pulling the power plug Caution! Make sure the bulbs are cool before touching them. or disconnecting the main circuit breaker. 1. Extract the guard by prising it out with a small First cleaning flat head screwdriver or • Remove the protective film something similar. • Clean with a damp sponge and a little neutral soap 2.
GB Troubleshooting If something does not work, make the following simple checks before contacting Technical Service: If the hood does not operate: Check that: • the unit is powered up. • a speed has been set. If the hood is not working effectively: Check that: • the selected motor speed is sufficient to handle the amount of smoke and steam being produced. • the kitchen is adequately ventilated for the unit to take air in. • the charcoal filter is not exhausted (filter version).
GB PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24 13
GB After Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us – the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in the country offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointservice.co.
Guarantee GB 12 months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
195124204.00 05/2014 - XEROX FABRIANO GB Indesit Company S.P.A. Viale Aristide Merloni,47 60044 Fabriano (AN) www.hotpoint.co.