Instruction for Use

5019 618 33100/A
LI29WA
FIN
NL P I GR
E
S
N
DK
D
F
GB
CZ SK H
PL
RUS
BG
RO
Grease filter cleaning required: GREEN led FLASHING (read the relevant instructions in “Reset and configuration of filter
saturation signalling”)
Carbon filter cleaning or changing required: ORANGE (amber) led FLASHING (read the relevant instructions in “Reset
and configuration of filter saturation signalling”)
Control of bottom lamps
The bottom light can be switched on or off by pressing the “light button”.
Control of inside lamps
The inside lights can be switched on or off by PROLONGED pressing of the “light button”.
As well as as switching on and off, PROLONGED PRESSING also allows the brightness of the lamps to be adjusted.
Note: The switching on and off (and adjustment) functions alternate.
Reset and configuration of filter saturation signalling
Switch the hood on at any speed (see section above “Extraction speed (power) control”)
Reset grease filter saturation signalling (GREEN LED FLASHING on control panel)
Firstly carry out filter maintenance as described in the relevant section.
Press (prolonged for more than 3 seconds) the “extraction power selection” button; the LED stops flashing to indicate that
signalling has been reset, and the hood switches off.
Reset carbon filter saturation signalling (ORANGE (amber) LED FLASHING)
Firstly carry out filter maintenance as described in the relevant section.
Press (prolonged for more than 3 seconds) the “extraction power selection” button; the LED stops flashing to indicate that
signalling has been reset, and the hood switches off.
Deactivation of carbon filter saturation signalling (for particular applications)
Switch off the hood (see section above “Extraction speed (power) control”)
Press (prolonged for more than 5 seconds) the “extraction power selection” button; the LED flashes GREEN (amber) to
indicate that carbon filter saturation signalling has been deactivated.
To reactivate carbon filter saturation signalling, repeat the operation, and the LED will flash ORANGE.