Setup and user guide

8
EMPTY WATER TANK AFTER EACH DRYING CYCLE
Hold the handle and carefully pull out the water tank. Hold the full
water tank with both hands.
Empty the water and insert the container by pushing it back into
place. Make sure that it is properly inserted.
CLEAN DOOR FILTER AFTER EACH DRYING CYCLE
Open the door and remove the door lter by pulling it upwards.
Press the button to open the door lter. Remove the lint inside.
Close the lter and reinsert it in the right direction, so that it
completely integrates in the lter chamber.
CLEAN THE BOTTOM FILTER AFTER ABOUT EVERY FIFTH
DRYING CYCLE
Open the bottom ap. Hold the handle and pull out the bottom
lter.
Remove the foam from the bottom lter, to clean it. Clean the lter
foam and the lter by hand or under running water. Do not wash it
in the washing machine. Wring out the lter foam. Do not insert it in
the bottom lter dripping wet.
Fix the lter foam on the bottom lter. Clean the lter chamber of
the dryer with a damp cloth or carefully with a vacuum cleaner.
Insert the bottom lter again. Clap the lter handle down and close
the bottom ap.
MAINTENANCE AND CLEANING
AND PROBLEM SOLVING
For maintenance and cleaning
and for Troubleshooting see the
Use and Care Guide.
The Use and Care Guide can be obtained as
follows:
• After-Sales Service; using the phone
number in the warranty booklet
• Download from the Whirlpool website
http://docs.whirlpool.eu
CONTACTING AFTER-SALES SERVICE
Provide both numbers shown on the service sticker inside the door
when contacting the After-Sales Service team.
http://www.whirlpool.eu
The phone number can be found in the warranty booklet.
Whirlpool® is a registered trademark of Whirlpool, USA.
CARE AND MAINTENANCE
Switch o and unplug the
dryer before doing any
cleaning and maintenance.
Caution, the water in the
water tank can still be hot.
WARNING
EN
400010766337
001
n