Instruction for Use

EN5

IMPORTANT:In order to prevent the electronic circuits from overheating, and therefore

from being damaged, we recommend the following:

• Do not install the hob near a dishwasher or washing machine, so that the

electronic circuits do not come into contact with steam or moisture, which

could damage them.

If an oven is installed beneath the hob, make sure that it is equipped with a cooling system.

If the temperature of the electronic circuits exceeds the maximum permitted temperature,

the hob will switch off automatically; in this case, wait for a few minutes until the internal

temperature of the electronic circuits reaches a tolerable level, at which point it will be

possible to switch the hob on again.

• Switch the hob off after use.

INSTALLATION

• The hob must be set into a worktop between

20 mm and 50 mm deep

• There must be nothing between the hob and

the oven (cross rails, brackets, etc.).

• The distance between the lower face of the

glass ceramic hob and the cupboard or

separating panel must be at least 20 mm.

• If the hob is to be installed next to a column

unit, leave a distance of at least 100 mm from

the edge of the hob.

• Make an opening in the worktop of the

dimensions shown in the Product Description

Sheet supplied separately.

• Apply the supplied gasket to the hob (unless it

has already been fitted), after having cleaned

its surface.

Rear wall

Front