Instructions for use WASHER-DRYER ! This symbol reminds you to read this instruction manual.
Installation GB ! Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washer-dryer to inform the new owner as to its operation and features. ! Read these instructions carefully: they contain vital information on installation, use and safety. Unpacking and levelling Unpacking 1. Unpack the washer-dryer. 2. Check whether the washer-dryer has been damaged during transport.
Connecting the drain hose 65 - 100 cm Where it connects to the waste water pipe cut end off spigot or remove the blanking cap Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; The drain hose may be connected to an under-sink trap. Before connecting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot.
GB As the colours of the wires in the lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
Technical data Model Dimensions Capacity GB IWDD 7143 S width 59.5 cm height 85 cm depth 53,5 cm from 1 to 7 kg for the wash programme from 1 to 5 kg for the drying programme Electrical please refer to the technical connections data plate fixed to the machine maximum pressure 1 MPa (10 bar) Water conminimum pressure nections 0.05 MPa (0.5 bar) drum capacity 58 litres Spin speed up to 1400 rotations per minute Wash: programme 1; temperature 60°C; using a load Energy raof 7 kg.
Care and maintenance GB Cutting off the water and electricity supplies • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washer-dryer and help to prevent leaks. • Unplug the washer-dryer when cleaning it and during all maintenance work. 2. unscrew the lid by rotating it anticlockwise (see figure): a little water may trickle out.
Precautions and tips ! This washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only.
Description of the washer-dryer and starting a wash cycle GB Control panel WASH CYCLE PROGRESS DELAY TIMER button DISPLAY ON/OFF button FUNCTION buttons with indicator lights TEMPERATURE Detergent dispenser drawer knob Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”).
Indicator lights The indicator lights provide important information. This is what they can tell you: Wash cycle phase indicator lights Once the desired wash cycle has been selected and has begun, the indicator lights switch on one by one to indicate which phase of the cycle is currently in progress.
Wash cycles Table of wash cycles Wash cycles GB 5 6 7 8 9 Daily White Cotton: extremely soiled whites. White Cotton (1): heavily soiled whites and resistant colours. White Cotton (2): lightly soiled whites and delicate colours. Cotton: heavily soiled whites and resistant colours. Coloured Cotton (3): lightly soiled whites and delicate colours. Synthetics: heavily soiled resistant colours. Special Wool: for wool, cashmere, etc. Silk/Curtains: for garments in silk and viscose, lingerie.
Personalisation Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash . The washer-dryer will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. Setting the drying cycle Turn the DRYING knob to select the desired drying option. There are two options: A - Based on time: From 40 minutes to 180.
Detergents and laundry GB Detergent dispenser drawer Good washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. ! Do not use hand washing detergents because these create too much foam. 1 2 3 Open the detergent dispenser drawer and pour in the detergent or washing additive, as follows.
Troubleshooting Your washer-dryer could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be solved easily using the following list. GB Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • • • • • The machine does not dry.
GB The machine is noisy. • There will always be some motor, pump and drum noise during spin. The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage.
Product Guarantee and Repair Information Guarantee 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase.
195146697.01 10/2016 GB Indesit Company Spa Viale Aristide Merloni, 47 60044 Fabriano (AN) Italy www.indesit.co.