Instructions for use
Important safety instructions 4 Safeguarding the environment 6 Before using the appliance 6 Precautions and general recommendations 7 Energy-saving tips 7 Electrical connection for Great Britain and Ireland only 8 Using for the first time 8 Maintenance and cleaning of the applicance 8 Replacing the light bulb or LED (depending on the model) 9 In the event of non-use of the applicance 9 In the event of an interruption to the power supply 9 Refrigerator compartment 9 Freezer compartmen
Important safety instructions gas without environmental impact, but is flammable. Therefore, make sure the refrigerant circuit pipes are not damaged. Keep special attention in case of damaged pipes emptying the refrigerant circuit. • C-Pentane is used as blowing agent in the insulation foam and it is a flammable gas. Pay special attention during disposal operations.
• During installation, make sure the appliance does not damage the power cable. • Do not pull the aplliance power cable • The appliance must be handled and installed by two or more persons. • Installation and maintenance including replacement of the supply cord must be carried out by the manufacturer or a qualified technician, in compliance with the manufacturer’s instructions and the local safety regulations in force.
Safeguarding the environment 1. Packing The packing material is 100% recyclable and bears the recycling symbol . For disposal, comply with the local regulations. Keep the packing materials (plastic bags, polystyrene parts, etc.) out of the reach of children, as they are a potential source of danger. removing the doors and shelves so that children cannot easily climb inside and become trapped.
Precautions and general recommendations INSTALLATION • Be careful not to damage the floors (e.g. parquet) when moving the appliance. • Make sure the appliance is not near a heat source. • Install and level the appliance on a floor strong enough to take its weight and in a place suitable for its size and use. • The appliance is arranged for operation in places where the temperature comes within the following ranges, according to the climatic class given on the rating plate.
Electrical connection for Great Britain and Ireland only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug.
Replacing the light bulb or LED (depending on the model) Always disconnect the appliance from the power supply before replacing the light bulb. Then follow the instructions based on the type of light bulb for your product. Replace the light bulb with one with the same features, available from the Technical Assistance Service and authorised sellers. Light type 1) To remove the light bulb, unscrew it in an anti-clockwise direction, as shown in the figure. Wait 5 minutes before reconnecting the appliance.
which is ideal for storing fresh meat and fish. Warning: do not clean refrigerator accessories in a dishwasher. Note: the ambient temperature, how often the doors are opened and the position of the appliance may affect the internal temperatures in the two compartments. Set the temperatures depending on these factors. Note: in very humid conditions, condensation may form in the refrigerator compartment, especially on the glass shelves.
How to defrost the freezer compartment (depending on the model) For frost free models it is not necessary to carry out any defrosting procedures. For other models, the build up of frost is a normal occurrence. The quantity and speed of frost accumulation varies depending on the ambient conditions and how often the door is opened.
“Zero Degrees” compartment (depending on the model) The “Zero Degrees” compartment is specifically designed to maintain a low temperature and the correct humidity to preserve fresh food for longer (for example, meat, fish, fruits and winter vegetables). Turning on and turning off the compartment The internal temperature of the compartment is approximately 0° when the compartment is turned on.
Removing the “Zero Degrees” compartment: Carry out the following steps: - to make it easier to remove the compartment, we recommend that you empty (and possibly remove) the lower door shelves - turn off the compartment - remove the compartment by rotating it upwards - remove the white plastic shelf under the compartment. Note: it is not possible to remove the upper shelf and side supports.
Printed in Italy 04/2017 400011103927 GB