Instruction for Use

15
Select program
Overview of programs
The max. possible number of programs is
illustrated in the chapter “Chart”. The
corresponding programs for your appliance can be
found on the panel.
Choose program according to the attached
table of programs.
Duration of the program depends on the
external conditions in the apartment,
temperature and pressure etc.
Wash cycle
The dishwasher door must be closed and the
water tap open.
To pause the program (e.g. if you want to
insert an item):
- Open the door with caution (the program
pauses) and insert the item/s, (beware of HOT
steam!).
- Press the START button and close the door
within 3 seconds (the program resumes the cycle
from where it was interrupted).
To Cancel the program on running:
- Open the door, press the CANCEL/Off button
and close the door.
- (Water drains for up to 1 minute then the
appliance switches off).
To change the program in progress:
- Open the door, press the CANCEL/Off button
to cancel the running program and close the
door.
- (Water drains for up to 1 minute then the
appliance switches off).
- Open the door and press any button except
CANCEL/Off button to switch on the appliance.
- Select a new program.
- Press the START button and close the door
within 3 seconds.
Switching off the appliance. Everything OK...
After the program is completed appliance turns
into Standby mode automatically. All indicator
lamps switch off.
Exercise caution when opening the door: beware
of hot steam.
Unload the appliance starting from the lower rack
in order to avoid any residual drips of water falling
onto crockery below.
For even better drying results, leave the
dishwasher door open a little before
unloading in order to allow the steam to
dissipate, helping the dishes to dry. The
underside of the kitchen worktop must be
protected (see instructions in ‘Assembly
instructions’).