Instruction for Use

20
What to do if...
If fault occurs, before contacting the After-sales Service, make the following checks to try and
remedy the problem. Most faults can be remedied by taking the following action, quickly restoring
normal appliance operation.
The appliance... Possible causes... Solutions...
Display shows:
CHECK SALT or
REFILL SALT
Salt reservoir is empty. Refill reservoir with salt.
Adjust water hardness.
Display shows:
CHECK RINSE AID or
REFILL RINSE AID
Rinse aid dispenser is empty. Refill dispenser with rinse aid.
...is not working/will not start
The appliance must be switched on. Check the household circuit fuse if
there is no power supply.
The appliance door doesn’t close. Check if the appliance door is closed.
“Delay” option is ON. Check whether the "Delay" option has
been selected. If it has, the appliance
will start once the set time has
elapsed. If necessary, RESET the
appliance by pressing or start the
cycle immediately by pressing .
Display shows:
NO WATER!
CHECK CONNECTION
MORE INFORMAITON
IS AVAILABLE IN
THE INSTRUCTIONS
(CODE F6-E1)
Water tap closed. The water tap must be open.
Water pressure is too low. The water tap must be fully open
during water inlet (minimum capacity:
0.5 litres per minute).
Kinked water inlet hose or closed inlet
filters.
The water inlet hose must not be
kinked and the relative inlet filter in
the water tap connector must not be
dirty or clogged.
Display shows:
CYCLE STOPPED
CHECK DRAIN HOSE
MORE INFORMAITON
IS AVAILABLE IN
THE INSTRUCTIONS
(CODE F8-E1)
Dirty filters. Clean the filters.
Kinked drain hose. The drain hose must not be kinked.
Syphon hose connection closed. The closure disk of the syphon hose
connection must be removed.
Display shows:
CYCLE STOPPED
CHECK FILTER
MORE INFORMAITON IS
AVAILABLE IN
THE INSTRUCTIONS
(CODE F6-E3)
Dirty filters or spray arms. Clean filters and spray arms.
Too little water in the appliance
system.
Concave items (e.g. bowls, cups) must
be arranged facing downwards in the
rack.
Drain hose incorrectly fitted. The drain hose must be fitted correctly
(for high mounted appliances, leave
min. 200 - 400mm from the lower
edge of the appliance) - see Assembly
Instruction.
High level of foam inside. Repeat without detergent or wait until
foam disappears.