Instruction for Use

The water filter is located below the freezer

compartment door.

1. Locate the water filter cartridge cap in the front base

grille below the freezer compartment door. Rotate the

cap counterclockwise to a vertical position and pull the

cap and filter cartridge out through the base grille.

NOTE: Since there is water in the cartridge, some

spilling may occur.

2. Remove the cartridge cap by sliding it off the end of

the old cartridge. The cap will slide to the left or right.

DO NOT DISCARD THE CAP.

3. Take the new cartridge out of its packaging and

remove the protective cover from the o-rings.

4. Slide the cartridge cap onto the new cartridge as

shown.

5. With cartridge cap in the vertical position, push the

new filter cartridge into the base grille until it stops.

Rotate the cartridge cap clockwise to a horizontal

position.

6. RUN WATER THROUGH THE DISPENSER

UNTIL THE WATER RUNS CLEAR (about 9-14

litres or 6-7 minutes). This will clean the system and

clear air from the lines.

NOTE: as air is cleared from the system, water may

spurt out of the dispenser.

Ordering replacement filters

To order more water filter cartridges, please contact your

KitchenAid Customer Care Centre.

Changing a water filter cartridge

5019_715_02010_GB_IFU_SbS.qxp 12-03-2007 9:36 Pagina 18