Instruction for Use

Switching On (pulling the drawer out to working position)

Always pull the drawer out to its full extension so that the

glass lid can open fully.

Switch the machine on using the On switch on the front right

hand side.

The control panel leds light up and a brief acoustic signal

indicates the machine has been switched on. At this point the

machine runs a set-up cycle lasting approximately 2 seconds;

do not press any buttons until set-up has been completed.

Vacuum Cycle for Kitchen Aid bags

At the start of each cycle, a brief acoustic signal is emitted.

The cycle automatically proceeds as follows:

• The air extraction phase is indicated by the ashing of the

function button. This phase lasts approximately 2 minutes

and 30 seconds.

• The heat sealing phase is indicated by the function button

led remaining lit. This phase lasts 9 seconds. This is followed

by a cooling phase lasting approx. 5 seconds.

• During the subsequent exhaust phase all the led indicators

return to their initial state. The exhaust valve remains open

for 20 seconds. During this time, no function can be selected.

• Once the vacuum chamber is decompressed, the lid can be opened and the sealed bag removed.

• At the end of the cycle, a brief acoustic signal is emitted, indicating that the machine is ready to perform

another cycle.

• The total duration of the cycle is about 3 minutes (to reopening of the glass lid)

The cycle can be stopped in advance by pressing the button

. In this case, the machine will not

proceed with sealing and the chamber will be decompressed. Wait for approximately 20 seconds and the

acoustic signal before starting another cycle.

Vacuum cycle for KitchenAid containers

At the start of each cycle, a brief acoustic signal is emitted.

The cycle automatically proceeds as follows:

• The vacuum phase is indicated by the function button led ashing. This phase lasts approximately 45

seconds.

• During the subsequent exhaust phase all the led indicators return to their initial state. The exhaust valve

remains open for 20 seconds. During this time, no function can be selected.

• Once the vacuum chamber is decompressed, the lid can be opened and the vacuum container

removed.

• At the end of the cycle, a brief acoustic signal is emitted, indicating that the machine is ready to perform

another cycle. The chamber is decompressed, enabling the container to be removed.

• The total duration of the cycle is about 1 minute (to reopening of the glass lid)

The cycle can be stopped in advance by pressing the button

. The chamber is decompressed and the

glass lid will lift. Wait for approximately 20 seconds and the acoustic signal before starting another cycle.

Machine operation indications