&ti SERIES AUTOMATIC WASHER Design 2000” ~K&Capacity LA33OOXP
Parts and features LAUNDRY INtUh “‘^‘?MATION 1 rr,LNTER I CYCLE CONTROL KNOB AND 1 TEMPERATURE -CLOTHES GUARD - AGITATOR - BASKET -TUB Remove the Consumer Buy Guide label. It will be easier to remove before the washer is used. You should wipe out the basket with a damp cloth before using to remove dust from storing or shipping. Cops your .Model and Serial Numbers When youneed service or call wtth a question, have this InformatIon reads 1.
Your responsibilities Read this “Use and Care Guide” and your “Laundry Guide” carefully for important use and safety information. You are personally responsible for making sure that your washer. _. l is installed by a qualified installer 9 is properly installed and leveled on a floor that can support the weight.’ l is connected to the right kind of outlet, electric supply, water supply and drain: l is properly grounded. l is used only for jobs normally expected of home automatic washers.
Starting your washer Before starting your washer ~ e:b\ 1 Measure and add detergent 2 Place sorted load In washer 3 Start washer ~ Select CYCLE and WASH TIME; 1. Start the washer Fill Area A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise B. Stop on a number in the cycle you want. The numbers are minutes of wash time. The drawing shows10 minutes of agitation in the REGULAR HEAVY Cvcle.
2. To select a WASH WATER TEMPERATURE HOT WATER con be selected only in the REGULAR HEAVY Cycle Turn the Control Knob to12 or14 minutes In the REGULAR HEAVY Cycle All rinses use cold water. This saves energy and helps prevent wrinkles from setting into fabrics. 3. WARM WATER can be selected by turning the Control Knob to 8 or10 minutes in the REGULAR HEAVY Cycle. l A worm wash is preset in the SHORT Cycle. Just turn the Control Knob to the 6 or 8 mrnute setting in that cycle.
What happens in each cycle* Each cycle has been designed for different ktnds of fabrics Numbers on the dial In each cycle ore the minutes of WASH agitation time.
clockwise until It points to OFF and the cycle ends NOTE:You may hear the sound of water spraying some cycles.
Other operating instructions For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent [Extra detergent can require an extra rinse ] l l l l Push Control Knob In Turn clockwise to any l on the dial See drawing. Pull Control Knob out.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off. This takes the pressure off the water inlet valve and hoses. AFlER WASHING, use a sofl dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry, Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
Winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer is stored or moved during the cold weather.. 1. Shut off both water faucets. Disconnect and drain water inlet hoses. To use the washer 2. Put a quart of automobile-type antifreeze in the basket. again.. . 1. Flush water pipes and hoses. 2. Connect hoses to the washer. 3. Turn on the water faucets. 10 3. Set the washer for c DRAIN and SPIN (see page 81.
If you need service or assistance, we suggest you follow these four steps: I. Before calling for assistance.. . 3. If you need service*.
whirlpwol Home Making Part No. 387408 81985 Whirlpool your world A *kpphances a httle easier Printed in U.S.A.
