use&care guide Whirlpool AUTOMATIC WASHER Super Capacity Model LA3800XS Microwave Ovens. Trash Compactors. Room Air Conditioners. Dehumidifiers. Automatic Washers. Clothes Dryers. Freezers.
Parts and features LAUNDRY INFORMATION CENTER CYCLE CONTROL KNOB AND TEMPERATURE SELECTOR MODEL AND SERIAL NUMBER PLATE (not shown) AGITATOR BASKET TUB Remove the Consumer Buy Guide label. It will be easier to remove before the washer is used. You should wipe out the basket with a damp cloth before using to remove dust from storing or shipping. Copy your Model and Serial Numbers here When you need service or call with a question, have this information ready: Model Number 1.
Your responsibilities Safety first Read this “Use and Care Guide” and your "Laundry Guide" carefuily for important use and safety information. You are personally responsible for making sure that your washer: • is instailed by a qualified installer. • is properly installed and leveled on a floor that can support the weight* • is connected to the right kind of outlet, electric supply, water supply and drain* • is properly grounded.* • is used only for jobs normally expected of home automatic washers.
Starting your washer Before starting your washer: 1. Measure and add detergent. 2. Place sorted load in washer. 3. Start the washer. Select CYCLE and WASH TIME; Start the washer Fill Area A. Push In the Control Knob and turn It to the right. It must be pushed in and turned only clockwise. B. Stop on a number in the cycle you want. The numbers are the minutes of wash time. The drawing shows 6 minutes of agitation in the REG ULAR NORMAL Cycle.
2. WASH TEMPERATURE нот WATER can be selected by turning the Control Knob to 12 or 14 minutes in the REGULAR HEAVY Cycle. All rinses use cold water. This saves energy and helps prevent wrinkles trom setting Into place. WARM WATER can be selected by turning the Control Knob to 8 or 10 minutes in the REGULAR HEAVY Cycle. • A warm wash is preset in the SHORT Cycle. Just turn the Control Knob to the 6 minute setting in that cycle. _ To select a 3. WATER LEVEL NORMAL 6 ШШ ppy HIGH WATCR LEVEL.
What happens in each cycle"' Each cycle has been designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts. After agitation starts, the knob turns clock-wise until it points to OFF and the cycle ends.
NOTE: You may hear the sound of water spraying during the spin parts of some | cycles. In some cycles, cold water is sprayed on the spinning load to help with the rinsing.
other operating instructions For a rinse and spin For a drain and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.) 1 Push Control Knob in. 2. Turn clockwise to any • on the dial. See above drawing. 3. Pull Control Knob out. The washer will fill to selected level: agitate 2 minutes; drain and spin. Your washer can be set to drain and spin out water. 1. Push Control Knob in. 2.
Caring for your washer & d WHEN NOT WASHING, keep both water faucets turned off, this takes the pressure off the water inlet valve and hoses. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry. Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
Service or performance problems caused by the use of any product not manufactured by Whirlpool Corporation are the responsibility of the manufacturer of that product. ^winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer is stored or moved during the cold weather... 1. Shut off both water faucets. Disconnect and drain water inlet hoses. 2. Puta quart of automotive-type antifreeze in the basket. To use the washer again... 1. Flush water pipes and hoses.
if you need service or assistance, we suggest you follow these five steps: !• Before calling for assistance... Performance problems often result from little things you con find and tlx your self without tools of any kind.
WHIRLPOOL AUTOMATIC WASHER WARRANTY LENGTH OF WARRANTY WHIRLPOOL WILL PAY FOR FULL ONE-YEAR WARRANTY From Date of Purchase FSP<^ replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a franchised TECH-CARE® service company. LIMITED FIVE-YEAR WARRANTY From Date of Purchase FSP replacement parts for any part of gearcase assembly if defective in materials or workmanship.
