AUTOMATIC WASHER ZhoTe; Capacity LA5580XS
Contents Page PARTS AND FEATURES IMPORTANT SAFETY INSTRUCTIONS OPERATING INSTRUCTIONS Starting Your Washer What Happens in Each Cycle OTHER OPERATING INSTRUCTIONS For a Rinse and Spin 2 3 4 4 6 10 10 01987 Whirlpool For a Drain and Spin Liquid Bleach Dispenser MAGIC CLEAN” Lint Filter CARING FOR YOUR WASHER Winterizing IF YOU NEED SERVICE OR ASSISTANCE WASHER WARRANTY..
Additional Safety lnsfrucfions ALWAYS store detergent, laundry aids and other materials in a cool, dry place where children can’t reach them-in a locked cabinet if possible. ALWAYS read and follow instructions on packages of detergent and laundry aids - especially warnings and precautions. HAZARDOUS FUMES can be formed if chlorine bleach is used in the same wash as ammonia or acids such as vinegar or rust remover.
Operating instructions Starting Your Washer Be sure to measure and add detergent, then place a sorted load in the washer before starting it. 1 . Select l l 2. a LOAD SIZE Turn the knob to point at a setting that describes the size of load you want to wash. Set the knob anywhere on or between EX SMALL [a few small items] and EX LARGE (a full load]. NOTE: Use the EX LARGE water level for best permanent press results.
4. Start the washer A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise. 6. Stop on a number in the cycle you want. The numbers are minutes of wash time. The drawing shows 10 minutes of agitation in the REGULAR NORMAL Cycle. C. Start the washer by pulling out the Control Knob. The washer will fill to the level you set with wash water of the selected temperature. After filling, the washer will agitate for the selected number of minutes. D.
What Happens in Each Cycle* Each cycle has different agitation and spin speeds designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts. After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends. REGULAR HEAVY Cycle A cycle for sturdily constructed fabrics that are heavily soiled.
NOTE: You may hearthe sound of water spraying during the spin parts of some cycles. In some cycles, cold water is sprayed on the spinning load to help with the rinsing. Gentle Wash System For better fabric care in the REGULAR and PERMANENT PRESS cycles, agitation speed is reduced during the last few minutes of wash time.
PERMANENT PRESS LIGHT Cycle A cycle designed for lightly soiled permanent press and some synthetic fabrics. The cool-down rinse helps keep wrinkles from setting into these fabrics. KNITS/GENTLE NORMAL Cycle A cycle that gently washes and spins moderately soiled delicate items and washable knits. rlndicates pausing period. the machine is for a brief soak rlndicates pausing period.
The washer will proceed to the REGULAR/HEAVY Cycle. If you want a different cycle to follow SUPER WASH, push in the cycle control knob, turn to the cycle and time you want, pull knob out to start.
Other operating instructions For a drain and spin For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.] 1. Push Control Knob in. 2. Turn ciockwise to any l on the dial. See above drawing. 3. Pull Control Knob out. The washer will fill to selected level; agitate 2 minutes; drain and spin. For agitation Liquid and spin speeds Your washer can be set to drain and spin out water. 1. Push Control Knob in. 2.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off, this takes the pressure off the water inlet valve and hoses. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry. Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
Wmterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer is stored or moved during the cold weather... 1. Shut off both water faucets. Disconnect and drain water inlet hoses. 2. Put a quart of R V or automobile type antifreeze in the basket. To use the washer again... 1. Flush water pipes and hoses. 2. Connect hoses to the washer. 3. Turn on the water faucets. 3. Set the washer for a DRAIN and SPIN [see page 10).
If you need service or assistance, we suggest you follow these five steps: 1 l Before calling assistance... for Performance problems often result from little things you can find and fix yourself without tools of any kind.
2. If you need assistance%. Call Whirlpool COOL-LINE” servIce assistance telephone number. Dlal free from anywhere in the U.S.: l-800-253-1301 and talk with one of our trained Consultants. The Consultant can instruct you in how to obtain satisfactory operation from your appliance or, if service is necessary, recommend a qualified service company in your area. 3. If you need service?..
Notes
WHIRLPOOL” AUTOMATIC WASHER WARRANTY AWOOI LENGTH OF WARRANTY WHIRLPOOL FULL ONE-YEAR WARRANTY From Date of Purchase FSP’ replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a franchised TECH-CARE p service company. LIMITED FIVE-YEAR WARRANN From Date of Purchase FSP replacement parts for any part of gearcase assembly if defective in materials or workmanship. The gearcase assembly is shown below.