AUTOMATIC WASHER Large Capacity Models LAWIOXP and LA5715XP I, wave Owns. Trash Cowactors Room Air Condltmners. Dehum~d~l~ers. Automatic Washers. Clothes Dryers, Freezers, . .. . i Aehgerator-Freezer z,..
Parts and features LOAD SIZE LAUNDRY INFORMATION CENTER / TEMPERATURE SELECTOR CYCLE ONTROL KNOB NT FILTER MODEL AND SERIAL NUMBER PLATE (not shown) -AGITATOR - BASKET -TUB Remove the Consumer Buy Guide label. It will be easier to remove before the washer is used. You should wipe out the basket with a damp cloth before using to remove dust from storing or shipping. Copy your Model and Serial Numbers When youneed service or call with a question, have this information ready: 1.
Your responsibilities Read this “Use and Care Guide” and your “Laundry Guide” carefully for important use and safety information. You are personally responsible for making sure that your washer.. l is installed by a qualifiedinstaller. l is properly installed and leveled on a floor that can support the weight.* l is connected to the right kind of outlet, electric supply, water supply and drain.’ l is properly grounded.’ l is used only for jobs normally expected of home automatic washers.
Starting your washer Select a 1. LOAD SIZE l l 2. Turn the knob to point at a setting that describes the size of load you want to wash Set the knob on or between EX SMALL [a few items] and LARGE [a full load). See your “Laundry on load sizes.
3. Start the washer A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise. B. Stop on a number in the cycle you want. The numbers are minutes of wash time. The drawing shows10 minutes of agitation in the REGULAR Cycle. C. Start the washer by pulling out the Control Knob. The washer will fill to the level you set with wash water of the selected temperature. After filling, the washer will agitate for the selected number of minutes. D.
What happens in each cycle* Each cycle has different agitation and spin speeds designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts. After agitation starts, the knob turns clockwise until it points to OFF and the cycle ends.
NOTE: You may hear the sound of water spraying some cy cles. In some cycles, cold water is sprayed with the rinsing. u during the spin parts of on the spinning load to help PARTIAL DRAIN (Pause) v NOTE: Always for permanent use cold rinse water press fabrics.
KNIT/GENTLE Cycle SOAK ,4ND PRE-W4SH Cycles Brief periods of agitation and soak time help remov ‘e heavy soils and certain stains that need extra pretreatment. Use recommended amount of detergent or pre-soa k additive. The SOAK Cycle should always be followed by a Wash Cycle.
~~~,~~~~~,~,~ +Pre-wash setting begins here, (see pagelo). Special care is needed when soaking or pre-washing See your “Laundry Guide” for proper use of this cycle. I laundry.
Other operating instructions For a rinse and spin For a drain and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.] l Push Control Knob in . Turn clockwise to any l on the dial See above drawing. l Pull Control Knob out. l The washer will fill to selected level with cold water, agitate 2 minutes, drain and spin. Your washer can be set to drain and spin out water l Push Control Knob In.
Liquid bleach dispenser Always measure bleach. Do not guess, Follow directions on the bottle for the amount to use. Never use more than 1 cup (250 ml) for a full load. Use less with lower water level settings. Use a cup with a pouring spout to avoid spelling. 1. Load the washer first. 2. Pour measured bleach carefully into dispenser. DO NOT let bleach splash, drip or run down into the washer basket. Undiluted bleach will damage any fabric it touches. 3. Start the washer.
for Model LA5715XP The SUDS-MISER” System Your washer has the SUDS-MISER” System it has two drain hoses One hose moves a portion of used wash water Into a storage tub and moves it back into the washer for use during the next wash The other hose carries water to another tub with an open drain. or to a standpipe drain. If you do not want to re-use wash water for a load, leave the stopper out of the storage tub so the water drains away. The SUDS-MISER@)System stores a portion of the wash water.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off This takes the pressure off the water inlet valve and hoses. AFlER WASHING, use a soft dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry. Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
Winterizing Because some water stays in the washer. freez ing can cause a lot of damage. If your washer IS stored or moved during the cold weather 1. Shut off both water faucets. Disconnect and drain water inlet hoses To use the washer 2. Put a quart of automobile-type antifreeze in the basket again.. . 1. Flush water pipes and hoses 2. Connect hoses to the washer 3. Turn on the water faucets 14 3.
If you need service or assistance, we suggest you follow these four steps: l. Before calling for assistance.. .
whirlpool Home Making Part No.
