AUTOMATIC WASHER !Suore;Capacity LA7800XM iwave Ovens Trash Compactors Room Air Condltloners Oehumldlllers Automatic Washers Clothes Dryers Freezers Refrlgeratar-Freezers
Parts and features LOAD SIZE SELECTOR \ LAUNDRY INFORMATION CENTER VnL TEMPERAT”“C SELECTC>R CYCLE / CONTROL , KNOB / MAGIC CLEAN LINT FILTER (not shown) FABRIC SOFTENER L LIQUID BLEACH MODEL AND SERIAL NUMBER PLATE (not shown) AGITATOR ‘I I -- BASKEl TUB FRemove the Consumer i Buy Guide label. It will be easier to remove before the washer is used. c r - Copy your Model and Serial Numbers When you need service or call with a question, have this information ready: I.
Your responsibilities Read this “Use and Care Guide” and your “Laundry Guide” carefully for important use and safety information You are personally responsible for making sure that yourwasher... l is installed by a qualifiedinstaller. l is properly installed and leveled on a floor that can support the weight: l is connected to the right krnd of outlet, electric supply, water supply and drain.’ . is properly grounded.
Starting Select 1. LOAD l l l your washer a SIZE 2. To change the setting on the LOAD SIZE SELECTOR, turn the knob to RESET. Then turn the knob to point at a setting that describes the size of the load you want to wash. Set the knob anywhere on or between HAND WASHABLE [a few small items] and EX LARGE (a full load] See your “Laundry on load sizes.
3. Start the washer A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise C. Start the washer by pulling out the Control Knob. The washer will fill to the level You set with wash water of the selected temperature. After filling, the washer will agitate for the selected number of minutes B. Stop on a number in the cycle You want. The numbers are minutes of wash time. The drawing shows 8 minutes of agitation in the REGULAR HEAVY Cycle. D.
What happens in each cycle Each cycle has different agitatron and spin speeds designed for different krnds of fabrics Numbers on the dial In each cycle are the minutes of WASH agitation time When the Cycle Control Knob IS set to a number and pulled out, the washer fills before agitation and tlmlng start After agitation starts, the knob turns REGL‘LAR HE,4\% Cycle High agitation and spin speeds help remove heavy sotls and spin water from heavy or sturdy cotton fabrics PERhl.
clockwise until it points to OFF and the cycle ends. NOTE:You may hear the sound of water spraying some cycles.
SO.Ui AND PRE-M’4Sli CJ cles Periods of agitation and soaking time clean stained, yellowed, gray or heavily soiled laundry. Use recommended amount of detergent. SUPER WASH Cycle Use for washing heavily soiled or stained load that needs extra agitation. Use twice the recommended amount of detergent when using Super Wash.
I + Pre-wash setting (see pagelO) begins Special care is needed when soaking or pre-washing See your “Laundry Guide” for proper use of this cycle. here laundry. The washer will proceed to the Regular/Heavy Cycle. If you want a different cycle to follow Super Wash, push in the cycle control knob, turn to the cycle and time you want, pull knob out to start.
Other operating For a rinse instructions and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.) l Push Control Knob in l Turn clockwlse to anY.on the dial See above drawing. l Pull Control Knob out l The washer WIII fill to selected level with cold water, agitate 2 minutes drain and spin.
Liquid bleach dispenser Always measure bleach. Do not guess Follow directions on the bottle for the amount to use. Never use more than 1 cup (250 mL) for a full load. Use less with lower water level settings. Use a cup with a pouring spout to avoid spilling 1. Load the washer first 2. Pour measured bleach carefully into dispenser. DO NOT let bleach splash, drip or run down into the washer basket. Undiluted bleach will damage any fabric. 3. Start the washer.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off. This takes the pressure off the water inlet valve and hoses. AFTER WASHING, use a sotf dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry. Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins. buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
WINTERIZIlVG Because some water stays In the washer, freezing can cause a lot of damage. If your washer is stored or moved dunng the cold weather 1. Shut off both water faucets. Disconnect and drain water inlet hoses To use the washer 2. Put a quart of automoblle-type antifreeze in the basket. again.. . I. Flush water pipes and hoses. 2. Connect hoses to the washer 3. Turn on the water faucets. 3. Set the washer for a DRAIN and SPIN [see page 10).
If you need service or assistance, we suggest you follow these four steps: 1. Before calling for assistance.. . Performance problems often result from little things you con find and fix yourself without tools of any kind. IF YOUR WASHER DOES NOT FILL: l l l Are fuses blown or circuit-breaker tripped? Are the water supply hOSeS kInked Is the Cycle Control Knob set and pulled out7 IF YOUR WASHER DOES NOT SPIN: Is the lid closed? l Is the power supply cord plugged In? .
2. If you need assistance”. . Call Whirlpool COOL-LINE service assistance telephone number. Dial tree from: Continental U.S. . (800) 253-1301 Michigan . . . . . . . (800) 632-2243 Alaska & Hawaii (800) 253-1121 and talk with one ofourtrained Consultants. The Consultant con Instruct you in how to obtain satisfactory operation from your appliance or, if service is necessary, recommend a qualified service company In your area. 3. If you need service *. . .
MaKing Part No. 385024 c 1984 Whirlpool natlc Washers. Clothes Dryers your Home 2 Appliances world a httle easier Printed Rev. A Corporation Freezers. Refr~gerator~Freezers Ice Makers. Olshwashers. Built-In Ovens and Surlace in U.S.A Units Ranges.
