AUTOMATIC WASHER Super Capacity Model LA79ooxs hcrowave Ovens. lrash Compactors, Room Au Condltloners. Oehumldlflers. Automatic Washers. Clothes Dryers. Freezers.
Contents Page PARTS AND FEATURES IMPORTANT SAFETY INSTRUCTIONS.. OPERATING INSTRUCTIONS.. Starting Your Washer What Happens in Each Cycle OTHER OPERATING INSTRUCTIONS..
Additional Safety Instructions ALWAYS store detergent, laundry aids and other materials in a cool, dry place where children can’t reach them- in a locked cabinet if possible. ALWAYS read and follow instructions on packages of detergent and laundry aids - especially warnings and precautions. HAZARDOUS FUMES can be formed if chlorine bleach is used in the same wash as ammonia or acids such as vinegar or rust remover.
Operating instructions Starting Your Washer yI$ Be sure to measure and add detergent, then Place a sorted load in the washer before starting it. 1 . Select l l l Select 2 . WATER TEMPERATURES a LOAD SIZE Turn the knob to point at a setting that describes the size of load you want to wash. Set the knob anywhere on or between EX SMALL [a few small items) and EX LARGE (a full load). To change the water level after the washer has started to fill, turn the knob to RESET,then the desired water level.
3. Start the washer A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise. B. Stop on a number in the cycle you want. The numbers are minutes of wash time. The drawing shows 10 minutes of agitation in the REGULAR NORMAL Cycle. C. Start the washer by pulling out the Control Knob. The washer will fill to the level you set with wash water of the selected temperature. After filling, the washer will agitate for the selected number of minutes. D.
What Happens in Each CyFle* Each cycle has different agitation and spin speeds designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before aaitation and timina starts. After aaitation starts, the knob turns clock wise until it points to OFF and thecycle ends, - REGULAR HEAVY Cycle DRAIN No Agitation A cycle for sturdily constructed fabrics that are heavily soiled.
NOTE: You may hear the sound of water spraying during the spin parts of some cycles. In some cycles, cold water is sprayed on the spinning load to help with the rinsing. Genlie Wash System For better fabric care in the REGULAR and PERMANENT PRESS cycles, agitation speed is reduced during the last few minutes of wash time. NOTE: Always for permanent use cold rinse water press fabrics.
PERMANENT PRESS LIGHT Cycle q REFILL A cycle designed for lightly soiled permanent press and some synthetic fabrics. The cool-down rinse helps keep wrinkles from setting into these fabrics. KNITS/GENTLE NORMAL COOL DOWN Cycle A cycle that gently washes and spins moderately soiled delicate items and washable knits. pauslng perlod. for a brief soak KNITS/GENTLE LIGHT Cycle A cycle that gently washes and spins lightly soiled delicate items and washable knits.
NOTE: Always for permanent use cold rlnse water press fabrics.
SOAK Cycle detergent or pre-soak additive. The SOAK Cycle should always be followed by a Wash Cycle. SUPER WASH Cycle Use for washing heavily soiled loads that require maximum soil removal. Double the amount of detergent recommended when uslng the SUPER WASH Cycle.
Special care is needed when soaking See your “Laundry Guide” for proper REFILL Selgted Level or pre-washing laundry. use of this cycle. The washer will proceed to the REGULAR/HEAVY Cycle. If you want a different cycle to follow SUPER WASH, push in the cycle control knob, turn to the cycle ant time you want, pull knob out to start.
Other operating instructions For a rinse and spin For a drain and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergeni can require an extra rinse.] I. Push Control Knob in. 2. Turn clockwise to any l on the dial. See above drawing. 3. Pull Control Knob out. The washer will fill to selected level; agitate 2 minutes; drain and spin. Your washer can be set to drain and spin out water. 1. Push Control Knob in. 2.
Liquid bleach dispenser Always measure bleach. Do not guess. Never use more than 1 cup (250 ml] for a full load. Use less with lower water level settings. Follow directions on bottle for safe use. Use a cup with a pouring spout to avoid spilling. L 1. Load the washer first. bleach carefully 2. Pour measured into dispenser. DO NOT let bleach splash, drip or run down into the washer basket. Undiluted bleach will damage any fabric it touches. 3. Start the washer.
Caring for your washer OF WHEN NOT WASHING, keep both water faucets turned off, this takes the pressure off the water inlet valve and hoses. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dry. Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
Winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer is stored or moved during the cold weather... 1. Shut off both water faucets. Disconnect and drain water inlet hoses. 2. Put a quart of R.V. or automobile type antifreeze in the basket. To use the washer again... I. Flush water pipes and hoses. 2. Connect hoses to the washer 3. Turn on the water faucets. 3. Set the washer for a DRAIN and SPIN [see page 12).
If you need service or assistance, we suggest you follow these five steps: 1. Before calling assistance... for l Performance problems often result from little things you can find and fix yourself without tools of any kind. If your washer does not fill: ,.
2. If you need assistance%. Call Whlrlpool COOL-LINE@ servIce assistance telephone number. Dlal free from anywhere In the U.S.: I-800-253-1301 and talk with one of our trained Consultants. The Consultant can instruct you in how to obtain satisfactory operation from your appliance or, if service is necessary, recommend a qualified service company in your area. 3. If you need service?..
Notes 18
Notes 19
WHIRLPOOL” AUTOMATIC WASHER WARRANTY LENGTH OF WARRANTY WHIRLPOOL FULL ONE-YEAR WARRANTY From Date of Purchase FSP” replacement parts and repair laborto correct defects in materrals or workmanship. Service must be provided by a franchised TECH-CARE” service company. LIMITED FIVE-YEAR WARRANTY From Date of Purchase FSP replacement parts for any part of gearcase assembly if defective in materials or workmanship. The gearcase assembly is shown below.
