Model Regular Whirlpool LASOOXK Capacity AUTOMATIC WASHER Use& Care Guide - LAUNDRY INFORMATION -A / CYCLE CONTROL KNOB h WATER TEMPERATURE SELECTOR -LOAD [ Copy I Your Model When you a question, need have and Serial Numbers SIZE SELECTOR Here service, or call this Inform&on with ready. 1 Complete Model ar;d Serial Numbers [from the plate under the lid near the hinge]. 2.
Before using your Washer Please read ihis booklet to be sure your washer IS instailed and used properly It will help you get the best results and longest life your washer wus designed to gave You are personally responsible for making sure that your washer... Is Installed by a qualified installer Is properly installed and leveled on a floor that can support the weight.’ l Is connected to the right kind of outlet, electric supply, water supply and drain l Is properly electrlcally grounded.
loading Washer your ,c For best washing results and energy savings, sort the laundry carefully. 1. Sort the Laundry into loads. l Group the laundry into loads that can be washed and dried together. See the Laundry Guide for information and samples of typical loads. l Try to mix large and small items for best movement in the washer. 2. Measure Detergent; Add to Washer Basket. l See detergent information on page 6 and in Section IV of the Laundry Guide.
Your automatic uasher IS easy to use. To make it even easle’ read the following steps before starting your first ioad Start your washer after you put In detergent, the load, and any other laundry aids occordlng to InformatIon on page 3 1. Set the LOAD SIZE SELECTOR. l Select the water level that matches the size of the load See page 5 for more ~nformatior: IMPORTANT sure the load For the best cleaning has enough water for 3. Select Washer.
Water levels load Sizes and The LOAD SIZE SELECTOR lets You control the amount of water that fills the washer. The water level can be set for extra small. medium or full loads. WATER LEVELS Setting EX SMALL MEDIUM LARGE *Approximate match size. Gallons/liters’ fill with 9 9137.5 13.5:51.1 16 9,‘64.0 load To save water and energy, the water level to the load For the best cleaning results, the load should move freely in the water Watch for rollover.
usually based on soft water and washers with normal-size tubs Use Important Detergent Information more detergent... Detergents and soaps clean by looserxng soil, and by holding it In the water so It drains away. If not enough detergent IS used, so11 and lint can settle back on the items in the load SOAP works best in soft water (O-4 grains hardness). In harder water. both the wash and rinse water should be softened. Use enough soap to make about 1% to 2 Inches (3.8 to 5 5 cm) of suds.
For a Pre Wash Use this settrnli for a sh#orter SOAK CYCLE (no rinse] Use enough1 detergent for a single wash. Add the load. l Set the LOAD SIZE SELECTOR. l Set wash water temperature tf you want high agitation and a high-speed sprn. use the dot In REGULAR HEAVY. If you want low agrtation and a low-speed spin, use the dot In KNITS GENTLE Use the dot in PERMANENT PRESS If you want high agrtation and a low-speed spin. For Spinning Push the Cycle Control Knob in and turn It to the 12.
Cycle Operation The numbers tn each cycle are for the number of minutes YOU want the washer to agitate before it drains and fills for the rinse.
perature you want with the TEMPERATURE SELECTOR. Rinse water in all settings. You set the amount of water fills the tub with the LOAD SIZE is cold that SELECTOR. NOTE: You may notice that some of the “SPIN”cycles have SPRAY RINSES. Cold water is sprayed on the spinning load to help rinse and remove detergent residue. if you turn to u cycle ond start the washer, but change your m/nd, push In on the Cycle Control Knob and turn to the right (clockwise) to the setting you wont. Then DU// out to start.
If You Need Service or Help, We suggest You Follow These Three Steps: 1. Before calling for service.
Before adding detergent use llquld detergent) Ir- Pre Wash setting 2.
FSP 1sa regIstered trademark of Whirlpool Corporation for quality parts Look for thrs symbol of quollty whenever FSP you need a replacement part s? for your Whrlpool appliance FSP replacement ports ~111fit right and work right because they are made to the same exacting spec~flcotlons used to build every new Whlrlpml oppllance 0 TLrlpool Home Appliances Benlon Harbor. Michigan. Aulomallc Washers, Clolhes Dryers. Freezers. Relrigeralor-Freezers, Ice Makers. Dishwashers.