Use& CareGuide Cycle control I knob Temperature selector Start button Unt screen models Drying rack (not shown) E92OOXW LG9201 XW IARGECAPACITYAUTOMATKDRYERS LE9100XT LG91OlX-TLE9200XW LG92OlXW
Contents Page ...... .3 Important Safety lnstructlons.. Additional safety instructions and your responsibilities ...................... .3 Cparatlng InstructIons Starting your dryer. ......................... 4 The automatic cycles .................... .6 TIMED DRYING ............................ .7 The FLUFF AIR cyde ..................... 7 Addltlonal Dryer Features Gentle Heat system ...................... .8 FINISH GUAROO setting ................ 8 Endof-cycle signal ........................ .
ImportantSafety Instructions To reduce the rlsk of fire, electrlcal shock, or Injury to persons when uslng your dryer, follow lncludlng the followlng: bask precautions, You are responsible for maklng sure that your dryer is installed, repaired and has parts replaced by a qualified person. l Use only fabric softeners sp&fcally labeled as not being harmful to the dryer. l FfRE HAZARD and DAMAGE to materials can resuft from: -drying rubber, rubber-like and heat sensitive materials with heat.
Operatinginstructions Starting your dryer Be sure to refer to the chart bebw and the Dryer Guide for proper sorting, bading and control setting information before starting your dryer. NOTE: Do not overdry. Overdrying can cause shrinkage, static ding, and damage some fabrics. SUGGESTED TYPE Of LOAD cononssnd lhflr EXTRA HEAW-Badspreads, mattrass padb, WNs HEAVYWEIGHT-Towels, jaans, cordumys. work dothes MEDIUMWEIGHTSheets, pillowcasas. cottul undarwear.
1. Select a cycle by turning the Cycle Control Knob either way. Stop when the indicator on the knob’s outer ring points to the cycle and setting you want. See pages 6-7 for further cycle information. 2. Prasa a temperature s&actlon which matches the type of fabric being dried. The indicator will appear over the temperature selectian you have chosen. 3. Push the Start Button to start the dryer. 4. To stop and restart the dryer: l Open the door or turn the Cycle Control Knob to OFF to stop the dryer.
Operating Contlnued lnstructlons The automatic cycles The automatic cycles albw you to select the degree of dryness you prefer for the cbthes being dried. The automatic DRY-MISEfVcontrol is a thermostat that senses the dryer air temperature. The dryer automatically shuts off when the selected dryness fs reached. 2 The Cycle Control Knob will not move until the bad is almost dry or the cooldown portion of the cycle has been reached.
number of minutes you want from 10 to 70. The last 5 minutes of this cycle are without heat to help make the load easier to handle. The FLUFF AIR cycle Fire Hazard Do not dry plastic or rubber Items with heat. Use FLUFF AIR cycle, or line dry. Failure to do so could result In flre or damaged ttems. The dryer does not heat when the Cycle Control Knob is set in FLUFF AIR. This cyde can be used to fluff or air dry bedding, plastic tablecloths, foam rubber pillows, stuffed toys, sneakers, etc. 1.
Additional Dryer Features Gentle tieat system For better fabric care, the Gentle Heat system helps prevent overdrying. Drying temperatures are automatiilly reduced to a bwer heat setting during the last few minutes of drying. Gentle Heat is followed by a cooldown period in all cydes to make your clothes easier to handle. 3 FINISH GUARD’ setting ‘5 r, /3 \=- When you are unable to remove a bad from the dryer as soon as it stops, wrinkles ten form.
Using the drying rack (models LE9200XW and LG9201 XW) The drying rack lets you dry items that you may not want to tumble. The rack does not move, but the drum turns. Make sure nothing hangs over the edge of the rack. 1. Fit rear legs of the rack into indentations in the back wall of the dryer. 2. Lower the front so the legs rest on the dryer opening. 3. Put wet items on top of the rack Leave space between them so air can reach all surfaces. 4. Close the door and start the dryer.
CaringFor Your Dryer Product and Fabric Damage Hazard Do not run the dryer wlth the llnt screen loose, damaged, blocked or mlsslng. Dolng so can cause overheating and damage to both the dryer and fabrics. Cleaning the lint screen The lint screen is located under a lid on top of the dryer. Clean it before each load. A screen blocked by lint can increase drying time. 1. Open the lid and pull the lint screen straight out. 2. Roll lint off the screen with your fingers.
Cleaning the dryer Electrical Shock 8nd Personal Injury Hazard l Turn off the 8kctrkal power before cleaning the lnterbr. l Make sure the dryer Is c&l. Failure to do so could result In electrkal shock or krjury. Fire Hazard l Use non-flammable cleaner. Failure to do so could result In 8n eXpk8bn. Garments which contain unstable dyes, such as denim blue jeans or brightly colored wtton items, may discolor the dryer interior.
Caring For Your Dryer Continued . . . . wit removal Lint can gather inside the dryer and be a fuel for fire. It is recommended the lint be removed every 2 to 3 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person. ff you have any questions, please call our Consumer Assistance Center at 1800-253-1301. Ebctrlcal Shock and Personal Injury Hazard l Unplug the power supply cord or turn off the electrlcal power before rmovlng dryer panels.
If You NeedService OrAssistance We suggest you follow these steps: 1. Before calling for asslstanca _. Performance problems often result from little things you can find and fix yoursetf without tools of any kind.
4. If you need FSP replacement parts’, FSP is a registered trademark of Whirlpool Corporation for quality parts. Look for this symbol of quality whenever you need a replacement part for your Whirlpool appliance. FSP replacement parts will fit right and work right, because they are made to the same exacting specifications used to build every new Whirlpool eppliance. To bcate FSP replacement parts in your area, refer to Step 3 or call the Whirlpcal Consumer Assistance Center number in Step 2 5.
Notes 15
WHIRLPOOL= Automatic Dryer Warranty LENGTH OF WARRANTY WlilRLPOOL FULL ONE-YEAR WARRANTY From Date of Purchase FSPO replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by an authorized Whirtpool~ service company. WHIRLPOOL DR006 WILL PAY FOR WILL NOT PAY FOR A. service calls to: 1. Correct the installation of the dryer. 2. Instruct you how to use the dryer. 3. Replace house fuses or correct house wiring or plumbing. 4. Replace light bulbs. B.
