AUTOMATIC DRYERS Electric Model LE7000XM and Gas Model LG7001 XM wave Ovens Trash Compactors.
Parts and features CYCLE CONTROL KNOB *LAUNDRY I INFORMATION CENTER TEMPERATURE SELECTOR START BUTTON / ! _I DRYER DRUM LOADING DOOR NUMBER PLATE Remove the Consumer Buy Guide label before using your dryer. It will be easier to remove. out Wipe the dryer drum with a damp cloth to remove dust from storing or shipping. C‘op~ jour Model and Serial humhers here 1. Complete Model ori3 Se:lu ‘41 r,, .I ._~~ --~~__ . [from the plate located a~ s’ :;- / FT ~ lefe -cI~T~: ‘;+‘~r~q L.l,nhev 2.
Your Responsibilities l Read this “Use and Care Gurde” and your “Dryer Guide” carefully for important use and safety information. You are personally responsible making sure that your dryer... l l l l for is installed by a qualified installer is properly maintained. is installed in an area protected from the weather. is properly installed and leveled in a well ventilated room’ on a floor that can support the weight. l l l l l is located in an area where the temperature is above 45 F (7.2 Cl.
Selecting a cycle and starting your dryer Before starting your dryer, be sure laundry is sorted and loaded properly (see your”Dryer Guide”] Be sure the door is tightly closed. TYPE OF LOAD I! - COTTONS - LINENS EXTRA HEAVY - Bedspreads, mattress pads, quilts.
Set TEMPERATI’RE 2. SEl,ECTOR Turn the Control Knob either way to point to the cycle and setting you want See page 6 for Information on the cvcles Changing to the lb stop and restart the dryer Push the 3. ST.AHT Hutton The dryer WIII start tumbling you push the START Button Turn the Temperature Selector .leeded drying temperature. To stop the dryer, open the door (or turn the Control Knob to OFF] To restart the dryer.
Operating instructions The automatic cycles The automatic cycles allow you to select the degree of dryness you prefer forthe clothes being dried. The Control Knob moves and stops several times until the load reaches the dryness setting you selected. Then the Knob automatically moves to OFF and tumbling stops. weight cotton items. The load tumbles without heat during the last 5 minutes. This helps make the load easier to handle. press, knits and other synthetic fabrics.
Drying FLUFF tips AIR The dryer does not heat when the Temperature Selector is set on FLUFF AIR. This setting can be used to fluff bedding, plastic tablecloths, foam rubber pillows, stuffed toys, sneakers, etc. 1. Set Temperature Selector on FLUFF AIR. 2. Turn Control Knob to the number of minutes you want in the PERMANENT PRESS Cycle. 3. Push START button.
End-of-cycle signal The dryer sounds a signal to let you know when the cycle IS finished. The signal cannot be turned off and is not adjustable. The signal is helpful when you are dryrng permanent press, synthetics and other items that should be taken out as soon as the dryer stops. [‘sing the drying rack The drying rack lets you dry items that you may not want to tumble; for example, sneakers, stuffed toys, knitted wool, etc. The rack does not move, but the drum turns.
Lint screen Clean Increase the lint screen before each load. A screen drying time and may be a FIRE HAZARD blocked by lint can ROLL the IInt off the screen with your fingers DO NOT rinse or wash the screen Open the Ild and pull the lint screen straight out DO NOT run the dryer with the lent screen loose. damaged or mtsslng 0 Doing so can cause overheatrng. can damage fabrrcs and can be a FIRE HAZARD.
Caring for your dryer Remove sharp objects from clothing before drying - pins, buckles, etc Close metal zippers. Never leave your dryer Wipe oft all spills with a damp. soft cloth Spills allowed to remain moy dull or damage the flnlsh Sharp or heavy objects should never be put on or in the dryer.
If you need service or assistance, we suggest you follow these four steps: 1. Before calling for assistance..
mirlR$E1 Home Maklng Part No. 691274 c 1984 Whirlpool Rev, A Corporation your world a llttle easier Printed in U.S.A.
