Manual
lli
If you need service or assistance,
we suggest you follow these five steps:
1. Before calling for
assistance...
Performance problems often result
from Iiffle things you can find and fix
yourself without tools of any kind.
If your washer does not fllh
• Is the power supply cord plugged
into a live circuit with the proper
voltage?
• Are both water faucets open?
• Have you checked your home's
main fuses or circuit breaker box?
• Are the water supply hoses kinked?
• Is the Cycle Control Knob set and
pulled out?.
If your washer does not spin:
• Isthe lid closed?
• Is the power supply cord plugged
into a live circuit with the proper
voltage?
• Have you checked your home's
main fuses or circuit breaker box?
If your washer drains at the wrong
time:
• The drain hose should be at least 28
Inches above the floor and secured.
20
• The drain hose should not fit tightly in
the drain pipe.
• Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Make sure the drain hose is higher
than the water level in the washer. If
It Isn't...
• The washer may seem to be drain-
ing during wash and rinse cycles.
• Water can siphonout. (See "Installa-
tion Instructions?)
Ifyour washer stops during a cycle:
• Remember, the washer pauses
briefly at differenttimes in each cy-
cle. Thesepauses are normal.
If your dryer does not run or heat:
• Is the power supply cord plugged
into a live circuit with the proper
voltage?
• Isthe door closed tightly?
• Did you push START?
• Have you checked your home's
main fuses or circuit breaker box?
• The FLUFFAIRsettingiswithout heat.
• The last minutesof heat settingsare
without heat. See page 14.
• Isthe gas turned on? Ifnot, turn the
Control Knob to OFF.Turn on gas.
Wait 5 minutes. Reset controls and
start.
If drying times seem too long:
• Isthe lintscreen clean? See page 17
of this book for cleaning instructions.
• See page 16 of this book and your
"Laundry Guide?