Instruction for Use

ARISTON DISHWASHER - Instructions for installation and use 19
D
ISHWASHER
Safety within your home
Your dishwasher was built in accordance with the strictest international safety regulations. They protect you and your family.
Read the instructions and information contained in this manual: they will provide you with useful hints as to installation, use and
maintenance safety. To avoid nasty surprises.
1. Dispose of the packaging
material carefully (follow
the instructions on how to
divide your rubbish up
provided by your local
Council)
2. After removing the
packaging, check to make
sure your appliance is
intact. If in doubt, contact
a qualified professional.
3. Your dishwasher must only
be used by adults and for
washing household dishes,
according to the
instructions included in
this manual. Do not touch
the appliance with wet
hands or feet or barefoot.
4. We discourage the use of
extension leads and multi-
ple plugs. If the electricity
supply wire is not long
enough, then have it
replaced with one of the
correct length and
remember that it should be
free of bends or dangerous
kinks.
5. If the appliance is not
operating properly or if
maintenance operations
are necessary, disconnect
the dishwasher from the
mains power supply
(unplug it!).
6. Keep children away from
the dishwasher when it is
open and keep detergents
out of their reach.
7. Your dishwasher is not to
be installed outdoors, not
even if the area is covered
by a roof: it is extremely
dangerous to leave it
exposed to rain and
thunderstorms.
8. Do not touch the heating
element during or straight
after a wash cycle.
9. Do not lean or sit on the
door when it is open, as
this could overturn the
dishwasher.
10. If the appliance
malfunctions, turn off the
water inlet tap and
disconnect the plug from
the wall socket. Then try
consulting the section
entitled "I you have a
If you have a problem, read this
Your dishwasher may not work or not function properly. In many cases, these are problems which can be solved without having to call for
a technician. Before calling the service centre, always check the points below.
The dishwasher won't
start
■ Is the water supply tap
turned on?
■ Is the water supply tap
connected to the hose
properly?
■ Has the water in your home
been cut off?
■ Is the pressure of the water
supply sufficient?
■ Is the hose bent?
■ Is the filter on the water
supply hose blocked?
■ Is the dishwasher door
open?
The dishes are not
clean.
■ Have you put the right
amount of detergent into the
dispenser?
■ Is the wash cycle suitable for
the dishes you have placed
inside the appliance?
■ Are the filter and microfilter
clean?
■ Can the sprayer arms turn
freely?
The dishwasher won't
drain.
■ Is the drain hose bent?
Limescale deposits or
a white film form on
the dishes.
■ Is the lid on the salt
container closed properly?
■ Is the rinse aid dosage
correct?
Error messages.
Your dishwasher is equipped with
a safety system which is able to
detect any operating anomalies.
These anomalies are reported by
one or two wash cycle indicator
lights "G" flashing rapidly.
Take a note of which lights are
flashing, turn the appliance off and
call for technical assistance.
Tap off alarm
If you have forgotten to turn the
water tap on, your appliance will
remind you of this by sounding a
few short beeps for a few minutes.
Turn the tap on and your appliance
will start up again after a few
minutes. Were you to be absent
when these beeps are sounded, the
appliance will be blocked automati-
cally and indicator lights 2 and 3
(wash and rinses) will flash rapidly.
Turn the appliance off at the ON-
OFF button, turn on the water tap
and wait approximately 20 seconds
before turning the appliance back
on. Re-select a wash cycle as indi-
cated in the "Selecting the wash
cycle" paragraph and the appliance
will start.
Clogged filter alarm
If the appliance is blocked and
indicator lights 1 (pre-wash) and 3
(rinses) flash rapidly, this means the
filter is clogged by large particles
of food residue. Turn the appliance
off, clean the filter thoroughly and
reposition it in its seat as illustrated
on page 20. Then turn it back on.
The selected wash cycle will start
up again.
Water load solenoid valve
malfunction alarm.
If indicator light 2 (wash) flashes
rapidly, TURN the dishwasher OFF
Troubleshooting
AND BACK ON AGAIN after one
minute. If the alarm persists, first
turn off the water tap to avoid any
flooding and then cut off the
electricity supply and call for
technical assistance.
You have checked
everything, but the
dishwasher still
doesn't work and the
problem persists?
Call an authorised service
centre near you and remember
to mention:
 the type of malfunction
 the model mark (Mod.) and
the serial number (S/N.)
indicated on the rating plate
located on the inner door, to
one side.
I only want an authorised
specialised technician with
original Ariston guaranteed spare
parts
problem, read this". If you
cannot resolve the
problem, then call the
service centre.
11. Once taken out of use,
appliances must be made
inoperable: cut the power
supply wire and damage
the door lock.
Never call upon the
services of
unauthorised
technicians and always
refuse spare parts that
are not originals.