Specification

CONNECTION

GAS SUPPLY

INSTALLATION USING LP GAS FROM A CYLINDER

· This stove is prepared to work with LP gas.

· Before the installation, make sure that local gas distribution conditions (Nature of gas and pressure) and

technical specifications of this range are compatible.

· Tools and parts required for installing your range using LP gas. Note: These tools and parts are not provided

with your range.

· The technical specifications for this range are on the identification label on the back of this product.

· The area where the stove will be installed, should provide the correct ventilation conditions required by local

regulations.

· This range is set to be installed on a location between 0 to 3800 meters above sea level.

· The gas hose should not get in contact with the back of the stove.

· The flexible PVC hose (reinforced polyester, 3/8”) for gas must withstand temperatures above 120° C and

must be approved by the local regulations and be within the validity period.

· If your range has a power cord, this should not come into contact with the back of the stove.

Tools and parts required for installing your range using LP gas.

Installation procedure

1. Gas valve for cylinder in accordance with local regulations.

Pressure 275 kPa (280 mm/water column) and output for gas hose. Confirm the expiry date.

2. Metallic bracket with screw adjustment.

3. The flexible PVC hose (reinforced polyester, 3/8”) for gas must withstand temperatures above 120° C and

must be approved by the local regulations and be within the validity period.

Use the hose only for domestic use. Make sure the hose is resistant to abrasion and chemicals.

The hose must be replaced before the expiration date indicated by the supplier or at least before 5 years of use.

The gas hose should not cross behind the back of the stove after installation.

The hose should be protected against direct exposition to sun light. The hose shouldn’t exceed a length of 1.25

4. Screwdriver

Put one of the metal clamps on one of the ends of the hose

and connect this end of the hose to the gas supply located on

the back part of the range. (fig. 1)

Note: These tools and parts are not provided with your range.