Specification

Once the range has been installed, it’s necessary to test the correct installation of the gas and

power supply. For this, place the range on its final location and turn on the cooktop burners and

the oven.

Testing your Range

Depending on the model of your range, the appliance may have 1 step or 2 step electronic

ignition. Follow this sequence to test the electronic ignition:

Ranges with 2 step electronic ignition:

If your range has the electronic ignition button: press and hold the button with the image next to

the cooktop controls to the Hi position (maximum flame). See the following image.

Oven burner

Depending on the model, your range may have an oven burner controlled by a thermal control

(thermal grades) or by a thermostat.

The oven knob can be found with the symbol .

The model with thermal control should have the following settings around the knob: from 120°C

– 149C° up to 235°C - 250°C.

If the range is equipped with manual or electronic ignition, depending on the model, the settings

around the knob will go from 150°C to 250°C.

To test the burner, follow these steps:

If for any burner the flame doesn’t light up after 5 seconds or you can’t hear the click of the

spark, follow these steps:

You will hear a click, this is the spark’s noise, it will light up the flame, once it is on, release the

button.

The spark will ignite and the flame will be on the Hi setting (maximum). Once the burner is lighted,

set the knob on the desired position. The same procedure can be followed to light up the other

burners.

d) Repeat steps 1 or 2 depending the cause of the failure.

Even when the power is down, the burners can still be lighted up. For this case, follow these

steps:

1. Light up a match and hold it close from the burner that you want to use.

2. Turn the knob to the Hi position (maximum flame), the flame should light up.

Turn the knob back to the OFF position (release the electronic

ignition button if your range is equipped with this button).

b) Make sure the range is connected to the power supply. The

electronic ignition system won’t work if the range is

unplugged.

c) Make sure the gas supply line is open (tank or shutoff

valve). Check the gas lines are not kinked, bended or

damaged.

Cooktop burners

MAXIMUM

FLAME

MINIMUM

FLAME