Installation Guide

Connection
GAS SUPPLY
INSTALLATION USING LP GAS FROM A CYLINDER
IMPORTANT:

This stove is prepared to work with LP gas.

Before the installation, make sure that local gas distribution conditions (Nature of gas and pressure) and technical
specifications of this range are compatible.

The technical specifications for this range are on the identification label on the back of this product.

The area where the stove will be installed, should provide the correct ventilation conditions required by local regulations.

This range is set to be installed on a location between 0 to 2000 meters above sea level.

The gas hose should not get in contact with the back of the stove.

approved by the local regulations and be within the validity period.
The flexible PVC hose (reinforced polyester,
3
/8”) for gas must withstand temperatures above 120° C and must be

If your range has a power cord, this should not come into contact with the back of the stove.
Tools and parts required for installing your range using LP gas.
Note: These tools and parts are not provided with your range.
1.
Gas valve for cylinder in accordance with local regulations.
Pressure 275 kPa (280 mm/water column) and output for gas
hose. Confirm the expiry date.
2. Metallic bracket with screw adjustment.
3.
Use the hose only for domestic use. Make sure the hose is resistant to abrasion and chemicals.
The hose must be replaced before the expiration date indicated by the supplier or at least before 5 years of use.
The gas hose should not cross behind the back of the stove after installation.
The hose should be protected against direct exposition to sun light.
The hose shouldn’t exceed a length of 1.25 m.
4. Screwdriver
25
approved by the local regulations and be within the validity period.
The flexible PVC hose (reinforced polyester,
3
/8”) for gas must withstand temperatures above 120° C and must be