Installation Guide

6
Installation procedure
1.
Put one of the metal clamps on one of the ends of the hose
and connect this end of the hose to the gas supply located
on the part back of the range (Fig. 1).
2.
Use a screwdriver to tighten the metallic clamp around
the hose (Fig. 2).
3. Place the other bracket on the other end of the gas
hose and connect the other end of the hose to valve in
the gas cylinder. Tighten the metal bracket with the
screwdriver (Fig. 3).
4.
Make sure the gas valve is closed before making the
connection to the gas tank (Fig. 4)
IMPORTANT:
5.
After the gas supply has been installed, check that
there is no leakage by applying soapy water to all
connections and joints of the hose and pipes. If
you see bubbles coming out, the installation was
not carried out correctly and must be installed
again (fig. 5).
The hose should not be bent, tense or too close to
heat sources.
26