Installation Guide

ManualsBrandsWhirlpool ManualsAppliances20 in. 4-Burners Freestanding Gas Range in Black with EvenClean Technology



It is not recommended to place the gas cylinder next to the range. In case of problems, consult your Whirlpool Service

Center.

IMPORTANT: The installation must be performed by qualified personnel.

INSTALLATION USING NATURAL GAS or LP GAS FROM A PIPE LINE

IMPORTANT:



This stove is prepared to work with LP gas.



The technical specifications for this range are on the identification label on the back of this product.



In order to connect this range to Natural gas or LP gas, it is necessary that the gas supply valve it’s located behind

the range and use the correct installation materials, approved by the local regulations.



The operations to convert your range to Natural Gas or LP gas from a pipe line must be performed by a

qualified installer from the Whirlpool Service Center.

NOTE: If you wish to use Natural gas with this range you will need a conversion kit according to the following

table. This kit can be ordered from the Authorized Whirlpool Solution Center.

RECOMMENDATIONS



After the gas supply has been installed, check that there is no leakage by applying soapy water to all connections

and joints of the hose and pipes. If you see bubbles coming out, the installation was not carried out correctly and

must be installed again.



The hose or pipe should not be bent, tense or too close to heat sources.



If the installation it’s not new, clean the pipes to prevent the range nozzles from clogging.



To facilitate the movement of the appliance, the installer should make a coil with the flexible copper piping and

install a shutoff valve in the supply line. The valve should be installed separate from the range and accessible for

whoever is operating the

range.

This valve must be outside of the range and accessible for the people using the appliance.

IMPORTANT

 After finishing the range conversion, the installer must tape a plate indicating the new conditions of the gas

supply for the appliance.

NOTE: For models LWW5305 and LWW5331, once the gas connection is done, proceed to connect the range to the electric power

supply. Make sure the installation is properly grounded.

Model

LP Gas to

Natural gas

LWW1002 W10478143

LWW5305 W10873443

LWW5331 W10873443

OPERATING LP GAS PRESSURE

2.75 kPa; 2750 pa; 27.5 mbar

OPERATING NATURAL GAS PRESSURE

1.76 kPa; 1760 pa; 17.6 mbar