User Guide

MaytagConnect360HandheldRegulatoryNotices
Federal Communications Commission (FCC) Compliance Notice
This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
– Reo
rient or relocate the receiving ante
nna.
– Incre
ase the separation between the equipment and receiver.
– Con
nect the equipment into an outlet on a circuit different from that to which the receiver is connec
ted.
– Consult the dealer or an
experienced radio/TV technician for hel
p.
This devi
ce complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not ca
use harmful interferenc
e, and
2. This device must a
ccept any interference received, including interference that may cause undesire
d
operation.
Cha
nges or modifications not expressly approved by Whirlpool Corporation could void the user’s authority to
operate the equipment.
RF Exposure Information
This equipment complies with FCC and ISED Canada radiation exposure limits set forth for an uncontrolled
environment. This equipment is in direct contact with the body of the user under normal operating conditions.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada (IC) Compliance Notice
This Device
complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not ca
use interference, and
2. This device must a
ccept any interference, including interference that may cause unde
sired operation of
the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.