Instruction for Use

ManualsBrandsWhirlpool ManualsMobile PhonesOK 1037EL DP.20 X/HA

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two

frames, lifting them

away from the spacers

A (see figure).

2. Choose which shelf

to use with the sliding

rack. Paying attention

to the direction in which

the sliding rack is to be

extracted, position joint

B and then joint C on

the frame.

3. Secure the two

frames with the guide

rails using the holes

provided on the oven

walls (see diagram).

The holes for the left

frame are situated at

the top, while the holes

for the right frame are

at the bottom.

4. Finally, fit the frames on the spacers A.

! Do not place the sliding racks in position 5.

Automatic cleaning with the FAST CLEAN

function

With the FAST CLEAN mode, the internal

temperature of the oven reaches 500°C. The

pyrolytic cycle is activated, burning away food and

grime residues. Dirt is literally incinerated.

Keep children away from the appliance during the

automatic cleaning cycle as surfaces may become

very hot. Particles may ignite inside the oven as a

result of the combustion process. There is no cause

for concern: this process is both normal and hazard-

free.

Before initiating the FAST CLEAN mode:

• clean the oven door;

• remove large or coarse food residues from the

inside of the oven using a damp sponge. Do not

use detergents;

• remove all accessories and the sliding rack kit

(where present);

• do not place tea towels or pot holders over the

oven handle.

! If the oven is too hot, pyrolysis may not start. Wait

for the oven to cool down.

! The programme may only be started once the oven

door has been closed.

To activate the Fast Clean programme:

1. Switch the control panel on by pressing the

button.

2. Press the

button; the TIME display will show

the default duration of 1:30 h (normal cycle), while he

TEMPERATURE display will show “Piro” and “nor”

alternately;

3. The desired cleaning level can be selected by

pressing the

button, then:

- pressing

+ to switch to the intensive cycle: the

duration is 2 h and the TEMPERATURE display

shows the text “Piro” and “int” alternately;

- pressing

- to switch to the economy cycle: the

duration is 1 h and the TEMPERATURE display

shows the text “Piro” and “eco” alternately.

Safety devices

• The door locks automatically as soon as the

temperature reaches a high value; the

icon

lights up on the display.

• pressing the

button cancels the cleaning

cycle at any time;

• If a malfunction occurs, the heating elements will

be switched off.

• Once the oven door has been locked, you cannot

change the duration and end time settings.

Programming delayed automatic cleaning

! Programming is possible only after selecting the

FAST CLEAN mode.

1. Then press the

button and set the end time

using the

+ and - buttons.

2. Once you have reached the desired end time,

press the

button again.

3. Press the

button to activate the programmed

mode.

4. When the selected time has elapsed, “END”

appears on the TEMPERATURE display and a

buzzer sounds.

Left

guide rail

Right guide

rail

Direction

of extraction