Instruction for Use

ManualsBrandsWhirlpool ManualsOtherOS 1A 200 H

INSTRUCTIONS FOR USE

DIAGRAM OF THE APPLIANCE (Fig. 1)

1. Lid handle.

2. Lock (if provided).

3. Seal.

4. Defrost water drain plug (depending on model).

5. Control panel.

6. Basket (depending on model).

7. Condenser (located at the rear).

INSTALLATION

• Refer to chapter “Before using the appliance”.

• Unpack the appliance.

• Remove the 4 protection pieces inserted between lid

and appliance (Fig 3).

• Warning: two of the four protection pieces must be

fitted in the seat of the condenser plastic supports,

located at the rear of the product (Fig. 3).

This is necessary to ensure the correct distance from the

wall.

• Ensure that the defrosting water drainage plug (if

provided) is correctly positioned (4).

• For best operation of the appliance and in order to

avoid damage when the lid is opened, leave a space of at

least 7 cm from the rear wall and 7 cm at the sides.

• Fit the accessories (if provided).

• Clean the inside of the appliance before using it.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

a. Red LED: when flashing, it indicates that an alarm condition

is present see TROUBLESHOOTING GUIDE"

b. Green LEDS: they indicate that the appliance is in

operation, and the temperature has been set as follows:

b1 less cold temperature (right light on), use this setting

with partial loads will optimize energy consumption.

b2 middle temperature (center light on)

b3 very cold temperature (left light on)

ALL Green LEDs ON: FAST FREEZING function is active;

see the section “freezing fresh food”.

c. Temperature setting button: to adjust the set

temperature and to activate/deactivate the fast freezing

operations.

To select the desired temperature, repeatedly press the

setting button (3): each time the button is pressed, the set

temperature is updated.

To activate/deactivate fast freezing function, pressing for

approximately 3 seconds: all green LEDs flash

simultaneously 3 times and then remain lit.

Note:

The settings will be saved in the memory even if a power

cut occurs. The time needed for the temperature inside the

freezer to reach the set value, can vary depending on

climatic conditions and the set temperature itself.

Switching on the appliance

• Plug in the appliance.

• The green LED lights up (middle temperature).

• The red LED flashes to indicate that the temperature

inside the appliance is not yet sufficiently low for food

storage. The red LED will normally switch off within the

first six hours after the appliance is switched on.

• Place food inside the product only when the red LED

has switched off.

Note: As the seal is tight, the appliance lid cannot be

reopened immediately after closing. Wait a few minutes

before re-opening the lid of the appliance.

FREEZING FOOD

Preparation of fresh food for freezing

• Before freezing, wrap and seal fresh food in: Aluminium

foil, cling film, air and water-tight plastic bags,

polyethylene containers with lids, provided they are

suitable for freezing foods.

• Food must be fresh, mature and of prime quality in

order to obtain high quality frozen food.

• Fresh vegetables and fruit should preferably be frozen

as soon as they are picked to maintain the full original

nutritional value, consistency, colour and flavour.

• Always leave hot food to cool before placing in the

appliance.

Freezing fresh food

• Place foods to be frozen in direct contact with the walls

of appliance (Fig. 4)

A) - foods to be frozen,

B) - foods already frozen.

• Avoid placing foods to be frozen in direct contact with

food already frozen.

• For best and fastest freezing, foods should be split into

small portions; this will also be useful when the frozen

items are to be used.

1. At least 24 hours before storing fresh foods inside the

product for freezing, activate the fast freezing function by

pressing button c for approximately 3 seconds. All green

LEDs (b) comes on.

2. Introduce the food to freeze inside the appliance, and

keep the door of the appliance closed for 24 hours. After

this period the food will be frozen. The fast freezing

Summary of content (4 pages)

PAGE 1
EN INSTRUCTIONS FOR USE DIAGRAM OF THE APPLIANCE (Fig. 1) 1. Lid handle. 2. Lock (if provided). 3. Seal. 4. Defrost water drain plug (depending on model). 5. Control panel. 6. Basket (depending on model). 7. Condenser (located at the rear). INSTALLATION • Refer to chapter “Before using the appliance”. • Unpack the appliance. • Remove the 4 protection pieces inserted between lid and appliance (Fig 3).
PAGE 2
INSTRUCTIONS FOR USE function can be deactivated pressing button c for approximately 3 seconds. If the fast freeze function is not manually deactivated, it will be automatically deactivated by the appliance after 50 hours. FOOD STORAGE Refer to the table on the appliance. Classification of frozen foods Put the frozen products into the appliance and classify them; the storage date should be indicated on the packs, to allow use within expiry dates listed in months in Fig. 5 for each type of food.
PAGE 3
INSTRUCTIONS FOR USE Note: Gurgling noises from the refrigerating circuit after the compressor cuts out are perfectly normal. 4. All LEDs are off and the product is not working. • Is there a power failure? • Is the plug properly inserted in the socket? • Is the electric cable intact? 5. All LEDs are off and the product is working. • Contact the After-Sales Service. 6. The compressor runs continuously.
PAGE 4