Health & Safety, Use & Care and Installation Guides www.whirlpool.
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED These instructions are valid if the country symbol appears on the appliance. If the symbol does not appear on the appliance, please refer to the technical instructions which will provide the necessary instructions concerning modification of the appliance to the conditions of use of the country. CAUTION : Use of the gas cooking appliance results in the production of heat, moisture and products of combustion in the room in which it is installed.
EN electrical connections and repairs must be carried out by a qualified technician. Do not repair or replace any part of the appliance unless specifically stated in the user manual. Keep children away from the installation site. After un packing the appliance, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest After-sales Service. Once installed, packaging waste (plastic, styrofoam parts etc.
IMPORTANT : When the gas cylinder or gas container is installed, it must be properly settled (vertical orientation). WARNING : This operation must be perfomed by a qualified technician. Use only flexible or rigid metal hose for gas connection. Connection with a rigid pipe (copper or steel) Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance.
EN Take care to replace also the bottom of the oven Wear protective gloves for cleaning and in its original position. maintenance. ELECTRICAL WARNINGS DISPOSAL OF PACKAGING MATERIALS The power cable must be long enough to connect the appliance, once fitted in its housing, to the main power supply. Do not pull the power supply cable.
OSA NG3F IX Burner Specications Grill burner Oven burner G20,20 mbar G25,25 mbar G20,25 mbar G30,28-30 mbar G31,37 mbar G30,37 mbar G30,50 mbar Gas natural Gas natural LPG LPG LPG Injector 0,92 mm 0,92 mm 0,60 mm 0,60 mm 0,55 mm Gas flow 0,143 m³/h 0,143 m³/h 109 g/h 109 g/h 109 g/h Power 1,50 kW 1,50 kW 1,50 kW 1,50 kW 1,50 kW Injector 0,97 mm 0,97 mm 0,65 mm 0,65 mm 0,60 mm Gas flow 0,171 m³/h 0,171 m³/h 131 g/h 131 g/h 131 g/h Power 1,
EN PRODUCT DESCRIPTION 1 5 6 2 3 7 1. Control panel 2. Shelf guides (the level is indicated on the wall of the cooking compartment) 3. Recess for roasting spit (if present) 4. Door 5. Electric grill 6. Light 7. Identification plate (do not remove) 8. Burner (not visible) 8 4 CONTROL PANEL 1. Thermostat selection knob Gas oven 1 2 2. Minute minder 3 3.
REMOVE THE LATERAL GRILLES To remove the side grilles, press down the grilles and lift them up as shown. Then, extract the grilles from their seats. To refit the grilles, insert the top support, then slide them to be fitted close to the cavity and push them up to fix in their original position. b a BEFORE USE HEAT THE OVEN A new oven may release odours that have been left behind during manufacturing: this is completely normal.
EN SET THE MINUTE MINDER OVEN LIGHT The oven light switches on every time an electric function is selected. It's possible to activate three combinations: Oven light and turnspit, oven light and electric grill, oven light with both turnspit and electric grill. If present, the electrical indicator light on the control panel will be switched on. The Minute minder can be set to a maximum time of 60 minutes. The timer operates independently of the oven: it does not activate any function and won’t stop it.
CLEANING AND MAINTENANCE Make sure that the oven has cooled down before carrying out any maintenance or cleaning. Do not use steam cleaners. Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance. EXTERIOR SURFACES • Clean the surfaces with a damp microfibre cloth. If they are very dirty, add a few drops of pHneutral detergent. Finish off with a dry cloth. • Do not use corrosive or abrasive detergents.
EN TROUBLESHOOTING Problem The oven will not switch on Possible cause Solution Power cut. Disconnection from the mains electricity. Check for the presence of mains electrical power and whether the oven is connected to the electricity supply. Wait at least one minute, then try to switch the oven on again and see if the problem persists. Switch-on procedure carried out incorrectly. Wait at least one minute and then repeat the steps described in the “How to operate the oven” section.
x2 90°C
EN 555 565 545 595 89° max 595 5 4 560 500 600 30 35 550 550 (min.) (min.
01 x2 x2 Whirlpool EMEA S.p.A. Via Carlo Pisacane n.