Consignes d'installation, utilisation, et sécurité www.whirlpool.
CONSIGNES DE SÉCURITÉ IL EST IMPORTANT DE LIRE ET OBSERVER Ces directives s'appliquent si le symbole du pays apparaît sur l'appareil. Si le symbole du pays n'apparaît pas sur l'appareil, vous devez vous référer aux consignes techniques qui contiennent les instructions nécessaires concernant la modification de l'appareil afin de se conformer aux conditions d'utilisation du pays.
FR N’entreposez pas de substances explosives ou Le système peut aussi obtenir l'air nécessaire de inflammables (p. ex. essence ou bombe aérosol) à façon indirecte, p. ex. d'une pièce voisine munie de l’intérieur ou près de l’appareil - un incendie tuyaux pour la circulation d'air comme décrit plus haut. Cependant, ces pièces ne doivent pas être pourrait se déclarer. une salle commune, une chambre à coucher, ou INSTALLATION Deux personnes minimum sont nécessaires une pièce qui présente un danger d'incendie.
Si l'appareil est installé sous le plan de travail, n'est pas écrasé. Utiliser seulement des tuyaux et n'obstruez pas l'espace minimum entre le plan de des joints d'étanchéité conforment à la travail et le bord supérieur du four - risque de réglementation nationale. IMPORTANT : Si vous utilisez un tuyau en acier brûlures. inoxydable, assurez-vous qu'il ne touche à aucune RACCORDEMENT AU GAZ AVERTISSEMENT : Avant l'installation, assurez- pièce mobile du meuble (p. ex. un tiroir).
FR 4. Enlevez la vis (V) puis le brûleur du four. Si le câble d'alimentation est endommagé, il doit être remplacé par un câble identique provenant du fabricant, d'un représentant du Service Après-vente, ou par toute autre personne qualifiée - vous pourriez vous électrocuter. Si le câble électrique doit être remplacé, contactez un centre de maintenance agréé. NETTOYAGE ET ENTRETIEN 5.
OSA YG3F IX Brûleur Spécifications Brûleur du gril Brûleur du four G20,20 mbars G25,25 mbars Gaz naturel G20,25 mbars G30,28-30 mbars G31,37 mbars G30,37 mbars G30,50 mbars Gaz naturel GPL GPL GPL Marque 0,92 mm 0,92 mm 0,60 mm 0,60 mm 0,55 mm Débit de gaz 0,143 m³/h 0,143 m³/h 109 g/h 109 g/h 109 g/h Puissance 1,50 kW 1,50 kW 1,50 kW 1,50 kW 1,50 kW Marque 0,97 mm 0,97 mm 0,65 mm 0,65 mm 0,60 mm Débit de gaz 0,171 m³/h 0,171 m³/h 131 g/h 131
FR DESCRIPTION DU PRODUIT 1 5 6 2 7 3 8 9 4 1. Bandeau de commande 2. Supports de grille (le niveau est indiqué sur la paroi du compartiment de cuisson) 3. Cavité pour broche (le cas échéant) 4. Porte 5. Élément chauffant supérieur 6. Éclairage 7. Élément de ventilateur 8. Plaque signalétique (ne pas enlever) 9. Brûleur (non visible) BANDEAU DE COMMANDE 1 Bouton de sélection du thermostat Contrôleur du four à gaz 2. Minuterie 2 3 3.
DÉPOSE DES SUPPORTS DE GRILLE LATÉRAUX Pour enlever les grilles latérales, appuyez sur les grilles vers le bas et levez-les comme indiqué. Puis, enlevez-les de leur siège. Pour remonter les grilles, insérez les supports supérieurs, posez les grilles contre l'enceinte et poussezles vers le haut pour qu'elles reprennent leur position d'origine. b a AVANT LA PREMIÈRE UTILISATION CHAUFFER LE FOUR Un nouveau four peut dégager des odeurs provenant de la fabrication : ceci est parfaitement normal.
FR ÉCLAIRAGE DU FOUR La lumière du four s'allume chaque fois qu'une fonction électrique est sélectionnée. Il est possible d'activer trois combinaisons : Lumière du four et tournebroche, lumière du four et gril électrique, lumière du four avec aussi bien le tournebroche que le gril électrique. Si présent, le voyant électrique sur le bandeau de commande sera allumé.
TABLEAU DE CUISSON RECETTE NIVEAU ET ACCESSOIRES TEMPÉRATURE (°C) DURÉE (MIN) Gâteau 170 - 180 35 - 45 3 Petit gâteau 170 - 180 25 - 30 3 Tourte 180 - 200 35 - 45 3 Pâtisserie 180 - 190 20 - 25 3 Cookies 170 - 180 20 - 25 3 Tarte aux pommes 180 - 190 50 - 70 3 Gâteau éponge 200/150* 20 - 25 3 100 50 3 Pizza 180 - 200 20 - 30 3 Lasagnes 180 - 200 25 - 40 3 Poulet grillé** 200 - 220 25 - 35 3 Poisson grillé** 200 - 220 25 - 35 3 Steak de veau** Max 15 - 20
FR NETTOYAGE ET ENTRETIEN Assurez-vous que le four a refroidi avant d'effectuer tout entretien ou nettoyage. N’utilisez pas de nettoyeur à vapeur. N’utilisez pas de laine d’acier, de tampons à récurer abrasifs, ou des détergents abrasifs ou corrosifs, ils pourraient endommager les surfaces de l’appareil. SURFACES EXTÉRIEURES • Nettoyez les surfaces à l’aide d’un chiffon en microfibre humide. Si elles sont très sales, ajoutez quelques gouttes de détergent à pH neutre. Essuyez avec un chiffon sec.
DÉPANNAGE Problème Cause possible Solution Coupure de courant. Débranchez de l'alimentation principale. Le four ne s'allume pas Le four ne chauffe pas Le four ne cuit pas bien Assurez-vous qu’il n’y a pas de panne de courant et que le four est bien branché. Attendez au moins une minute avant de réessayer de rallumer le four et voir si le problème est résolu ou persiste. Pas d'arrivée de gaz.
FR x2 90°C
555 565 545 595 89° max 595 5 4 560 500 600 30 35 550 550 (min.) (min.
FR x2 x2 Whirlpool EMEA S.p.A. Via Carlo Pisacane n.