Specifications

Document ID: 39080005 Rev: A Technical Support: 1-800-626-6912 Page 15 of 20
EUROPEAN TOUCH MOTOR SYSTEM
LOCKING CAP
The European Touch motor system has the added protection feature of being lockable.
1. Place the cap into position and turn clockwise until the locking pin is at the top right corner of
the motor mount
2. To remove cap the use of a tool is required
3. Insert tool shown in diagram (below) adjacent to locking pin
4. Gently turn the cap counter-clockwise to remove cap
CLEANING PROCEDURE
1. Gently turn the cover counter-clockwise to remove it (this will expose the entire water
chamber)
2. Use anti-bacterial soap or a solution 3% hydrogen peroxide to wipe the inner chamber. DO
NOT use chlorine or chlorinated products (such as diluted bleach) as this will damage
the plastics and VOID your warranty
3. Clean air supply line by gently sliding a “Q-Tip” (dipped in 3% hydrogen peroxide) into the air
canal
4. Replace the cap by gently turning it clockwise until snug (no need to over-tighten)