Operation Manual

Packing

• The packing box may be fully recycled as confirmed

by the recycling symbol.

Disposing of packaging and old Dryer:

• The dryer is built from reusable materials. The dryer

must be disposed of in compliance with local waste

disposal regulations.

• Before disposing, cut off the power cable so that the

dryer cannot be connected to the mains.

• The symbol on the product or on the

documents accompanying the product indicates that

this appliance may not be treated as household

waste. Instead it shall be handed over to the

applicable collection point for the recycling of

electrical and electronic equipment. Disposal must

be carried out in accordance with local

environmental regulations for waste disposal.

• For more detailed information about treatment,

recovery and recycling of this product please contact

your local city office, your household waste disposal

service or the shop where you purchased the product.

Energy saving tips

• Always dry a full load: depending on the type of

laundry and the programme/drying time. For more

detailed information, see the programme chart.

• Use the maximum spin speed allowed by your

washing machine, since draining the water

mechanically requires less energy. You will save time

and energy when running your drying cycle.

• Do not overdry the laundry.

• Clean the door filter after every drying cycle.

• Clean the bottom filter after every fifth drying cycle.

• Place your dryer in a room with a temperature

between 15° C and 20° C. In case of higher

temperature, ventilate the room, e.g. open the

window.

• Always select the correct programme/ drying time

for the load in order to obtain the desired drying

results.

• Select the gentle option only with small loads.

• When drying cotton, dry iron dry and cupboard dry

loads together. Start with the iron dry programme/

drying time setting, remove the laundry to be ironed

at the end of that cycle and dry the remainder of the

load on the cupboard dry setting.

• Set the programme selector knob always to the “0”

position after the end of the cycle.