Operation Manual

CLEANING THE BOTTOM FILTER

Open the bottom filter flap and set it aside. Lift up the handle of the

filter and pull the bottom filter out.

Open the filter by lifting on the latch of the filter frame.

Take out the foam from the inside of the filter.

Remove the lint on the surface of the foam by hand. Afterwards, clean

the foam under running water to remove any remaining lint from the

foam.

Remove the lint from both filter parts by hand. If a white substance

remains on the filter mesh that cannot be removed by hand, clean the

filter parts under running water. If necessary, use a soft brush.

Put the foam back into the filter frame.

Install the filter frame into the housing by inserting the tabs of the frame

into the slots on the filter housing and clicking the latch into place.

Please take care that the foam is not pinched between the filter parts.

Clean the filter housing and the mesh inside by hand, with a damp

cloth, or very carefully with a vacuum cleaner.

Install the filter again in the dryer, with the handle in horizontal

position. When the filter is fully inserted, move the handle downwards

to lock the filter in place. Ensure that the handle is fully engaged on

both sides behind the hooks of the housing area.

Fix the bottom filter flap again.

NOTE:

The filter foam should not be washed together with laundry in a

washing machine