Operation Manual

AFTER EACH DRYING CYCLE

• Switch off the dryer before cleaning or carrying out maintenance.

• Empty the water container at the end of each drying cycle.

• Clean the door filter at the end of every drying cycle.

Dryer exterior and control panel:

• Use a soft, damp cloth. Dry with a soft cloth.

• Do not use detergents containing solvents, scouring powder, glass or general purpose cleaners;

they may harm the surfaces.

Door seal, door, filter area:

• Use a damp cloth to wipe away lint.

• Since lint can go through the filter, occasionally clean the complete filter area (including below the

filter) with a brush, a damp cloth or a vacuum cleaner.

CLEANING THE DOOR FILTER

Depending on the model of your dryer, the door filter

can have different shapes.

A. Remove the complete laundry out of the dryer

before removing the lint filter.

B. Take the D filter out of the dryer and carefully

open the filter.

C. Carefully remove the complete lint from the lint

screen.

D. If the mesh is clogged and cannot be cleaned by

hand, run the filter under water and scrub with a

soft brush.

When the door filter is clean, put it back into the dryer.

Assure that it is positioned correctly before starting

the next drying cycle.

IMPORTANT:

• Be aware that the lint filter is always correctly positioned when laundry is put into the drum or is

taken out of it.

• Clean the door filter after each drying cycle.

CLEANING AND MAINTENANCE