ELECTRICBUILT-INGLASS SOLIDELEMENTCOOKTOP
1. BEFORE YOU BEGIN 3. CARPENTRY Read the following instructions completely and carefully. followed, they will simplify the installation job. See Figure 1 for the dimensions of typical counter top cutout. The cut-out must be located so that when the cook top is set in place there is at least 1% inches between the front edge of the cook top and the front edge of the counter top.
C. Attach the foam seal strip as follows: 1. Lay foam strip on bottom of cooktop (long side). Cut strip to fit. (See Figure 2) 2. Remove backing paper from strip. 3. Install strip l/e” in from edge along cooktop side. (See Figure 2) 4. Repeat steps 1 through 3 for the remaining 3 sides of cooktop. Junction box \ Cable from power supply I I ires D. Turn cooktop right side up and again support it on the end caps next to the cutout. 5.
6. Assemble the two clamps. (See figure 6) GIASSCOOKTOP FOAM THUMB COUNTER SEAL TOP SCREW BURNER BOX FIGURE 6 7. CHECK BURNER OPERATION REFER TO USE AND CARE GUIDE PACKAGED WITH THE BUILT-IN COOK TOP TO CHECK FOR PROPER CARE AND CLEANING OF YOUR BUILT-IN COOK TOP. BOX CAUTION: Do not touch the elements. They may be hot and you may get burned. Turn on each of the four (4) surface elements and check to see that they heat. Check the surface element indicator lights. 8.
