MO~LAR COOKTOPS Models RC88OOXP (3 Caoktop RC8300XP (2 Cooktop Surface Modules) Modules) Unlt Control Panel Grltl Module Surface Untt Modute One-Piece Chrome Reflector Bowl Model and Serial er Plate (Not Shown) Model RCWOOXP Surface Plug-In Surface Unit One-Piece Chrome Reflector Bowl Untl Module Grit1 Module Model RC8300XP (Modules can be Control Model If you have a question, mation ready: Copy Your Model or need service, Module and Serial Numbers Here have this inforModel Mo
Your responstbilitfrs l l . lnstallatlon and proper, rafe use are your personal responsibilities. Read this “Use and Care Guide” and the “Cooking Guide” carefully for Important use and tafety Informatlon. You must be sure your cooktop l l l is... installed and leveled in a countertop and cabinet that will hold the weight; installed in a well-ventilated area protected from the weather, properly connected to the correct electric supply and Instructions.“] grounding.
Using your cooktop , Surfi 7it C:ontrc ce Uni ItIC ookt surf0 ldule II7dic :ator NM0 Surfac :e Unit Signial Li / RC880OXP (3 Cooktop Modules] 4 RC8300XP (2 Cooktop Modules)
SURFACE UNIT CONTROLS Control knobs must be pushed in before turning them to a setting. They can be set anvwhere between HI One of the signal lights will glow when a surface unit is on. Be sure all lights are off when you are not cooking. PUSH IN Turn to setting ilnl ‘il you get dsed to the settings, ” use the following VI Use HI !o start ?oods cooking 3r lo bring Ilquid: to a boil. Surface unit will not turrl red if good CO~I- as a guide.
For the Grlr+ Module, use Vent or back controls as you wouid for surface controls If yc r:ant both the front and back halves of the grill to heat Srill on left Grill in the Cen’er Center ieft units Use both Rear Grill on the Right : i; : Right Rear e l Front . CHANGING COOKTOP MODULES Tt j Zcjoktop Modules will work on either side or the center of the cooktop. (Model QCBa-0C:XP The grill and griddle modules will fit only on the left side or center of the :.
1. To remove, lift 2. Lift front end 31 heating element and pull toward you oft grill 1. To replace, 2. Put In basket lower grease well Into opening with 3. 3. ceramic Lift out basket of ceramic rocks “ihy heating element terminal rcocks 4. Lift slightly at the back and remove the grease well, being careful not to spill fat drippings. 4. Place grills over heating element. into :eceptacle All parts must be cleaned after each use to avoid spoilage and odors. See page1 3.
USING THE COOKTOP MODULES OPTIONAL GRIDDLE Before usirrg the griddle for the first time Wash, rinse and dry griddle. l Use warm sudsy water. l DO NOT immerse grrddle l DO NOT use metal scouring pads or abrasrve cleaners. They will damage griddle 2. Lightly wipe with cooklng oil to season You don’t have to grease the griddle every time you use It. However, 011 or butter adds flavoring and aids browning. 1. 1. Lift and remove griddle c:over DO NOT replace grtddle ,.Jntil : cool 2.
GRILL MODULE A range hood should be used to help get rra of smoke while using the Grill Module (Whirlpool Model No’s RH8330 or RH8336 recommended for RC8300XP Cooktop: Model RH8348 for the RC8800XP Cooktop). Approximate Preheat Grill Module grill tar five minutes _‘D Cooklng Tlmes at suggested setting Weight or Thickness Internal Temperature Control Setting(s) 1 (25cm 1 (25cm, 140 F(60 C, 160 F(71 C] 170 F(76 C] HI 1 . :3 3cmj 1 (3 8cm) 1’. (3.
OPTIONAL ROTISSERIE :qe i;’ :issE’ Rear iupport I I u r nL) II Front Support 4. FJsh rht: kclnted brcI the Totor Insert front sup port tubs Into slots at front ot the Grill Module end of the sDlt all the way socket r .it the riandle end of the spit Into the high i iow slot (to match the motor socket posi;! x] of the Fwnt Support 1, ug ;n the Rotlsserle motor and turn on the t ,rIll Module See page 11 for suggested m,.
Approximate Food Beef Rolled rib (rare) Rolled rump Pork Rolled loin roast Spareribs Canadian bacon rotisserie cooking times: Internal Temperature Weight 140 F (60 ‘=I 140 F (60 Cl 3’zlbs. HI (I.5 kg1 3’4lbs HI (I.5 kg).- High 5lbs. HI High I‘Llbs. Hi High :‘I2 (1 kg1 Hi High 1 hr. 10 min 5 Ibs. _. ~(2 kg) Hi High 2 hr. 30 min. Hi Hrgh Hi High HI High Hi Hrgh 1 hr 45 min 2 hr. 45 min 2 hrs. 15 min. 2 hrs.
Cleaning and caring for your cooktop CONTROL PANEL AND KNOBS / Y SURFACE UNITS AND REFLECTOR BOWLS REMOVING 1. Be sure surface \ 1. 2. 3. 4. 12 Flnt make sure knobs pull knob straight off. \ units are OFF and COOL. ?-I are set on OFF then 2. Lift the edge of the unit opposite the receptacle just enough to clear the reflector bowl. 3. Pull the surface receptacle. 4. Lift out the reflector Use warm soapy water and a soft cloth to wipe the panel.
Terminal Receptacle 3. Hold the surface unit as level as possible with the terminal just started into the receptacle 4. While pusning the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. i. When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl. Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills.
If you need service or assistance, we suggest you follow these four steps: 1 Before l calling for assistance.. . 3 l If you need service”‘. . . Whirlpool nationwide Performance problems often result from little things you can find and fix yourself without tools of any kind. If nothing operates: Is the cooktop correctly wired into a live circuit with the proper voltage? (See Installation Instructions.
THIS PAGE INTENTIONALLY LEFT BLANK
FSP 1s a registered trademark of WhIrlpool Corporation for quallty parts Look for this FSP symbol of quallty whenever you need a replacement part ’ for your Whirlpool appliance FSP replacement parts WIII 111rlghl and work nght. because they are made to the same exacting speclflcatlons used to build every new WhIrlpool appliance 0 Benlon Harbor, Michigan. Aulomallc Washers. Clothes Dryers. Freezers, Relrigeralor-Freezers. Ice Makers. Dishwashers. BullI-in Ovens and Surlace Unils. Ranges. MIcrowave Ovens.