Electric Models RC8920XRH RC8950XRH (Shown with bptional Coil Element Module) MODULAR DOWN DRAFT COOKTOP
Contents Page BEFORE YOU USE YOUR COOKTOP IMPORTANT SAFETY INSTRUCTIONS PARTS AND FEATURES USING YOUR COOKTOP 1 Using the Control Knobs 2 Using the Coil Element Module 3 Using the Vent System 4 Using the Grill Module 5. Using the Solid Element Module 6. Using the Optional Griddle Module 7 Using the Optronal Smoothtop Module 8 Cook\-are CHANGING COOKTOP’MODUL;S Page 2 9 10 10 11 Coil Element, Solid Element and Smoothtop Modules Grill Module.
WIPORTANT 1. SAFETY INSTRUCTIONS DO NOI- allow children to use or play with any part of the cooktop. or leave them unattended near it They could be burned or injured. 7. DO NOT use water on grease fires. The fire will spread. Cover fire with large lid or smother with baking soda or salt. 2. DO NOT store things children might want above the cooktop. Children could be burned or injured while climbing on it. 8. DO NOT wear loose or hanging garments when using the cooktop.
Parts and features Model RC8920XRH GRILL MODULE ELtmtn I COIL Eltmtn \ REFLECTOk ’ vtI11 SYSTEM This model comes with a removable grill module on the lett side and a nonremovable coil element module on the right side. Other modules can be purchased and used in place of the grill module.
Model RC8950XRH REAR SURFACE UNIT FRONT I OPTIONAI ?!?’ tLtmENT MODULE I GREASE 1-v WELL 7 INTERLOCK - A ?\ GREASE CONTROL @g&T& \ Y- TV VENT SYSTEM COdKTOP This model comes with a grill module that can be used on either side. Several modules can be purchased and used in the other module opening, or in place of the grill module.
Using your cooktop SURFACE UNIT INDICATORS LEFT REAR SURFACE UNIT CONTROL 1. Using Surface GRILL CONTROL OR LEFl FRONT SURFACE UNIT CONTROL Surface or module Unit Indicators unit indicators show the surface operated by that control knob. -- l /I -/ RIGHT REAR SURFACE UNIT CONTROL the Control Knobs 1 / I l l The solid dot shows the surface unit that is controlled by that knob. The solid box shows that a module, such as a grill, can be controlled by that knob.
2. Using the Coil Element Module Use only flat-bottomed utensils for best results and to prevent damage Specialty items with rounded or ridged bottoms [woks, ridged bottom kettles] are not recommended. Until you get used to the settlngs, ,@: use the following ,q@ Use HI lo start foods cooklng or lo bring liquids to a boil Surface as a guide. .i@ Pat< “E” Use MED-HI to hold a ropld boll or to fry chlcken or pancakes units will not turn red It good contact Is made with bottom ot pan.
Approximate Preheat Grill Cooking the grill for 10 minutes FOOD Times on HI. Control Setting Steak(‘/, -% ) Rare Medium Well-done Steak (l-l% ) Rare Medium Well-done HI HI HI 5 Min. 6 Min. 8 Min. 4 Min. 6 Min 8 Min. HI HI HI 5-7 Min. 9-l 1 Min. 12-15 Min. 5 Min. 10 Min. 12 Min. Other: These foods must be turned and rearranged cooklng to provlde even cooklng results.
5. Using the Solid Element Module Use only flat-bottomed utensils for best results and to prevent damage to the cooktop. Specialty items with rounded or ridged bottoms (woks, ridged bottom canners ortea kettles) are not recommended. Solid elements are made of heavy cast-iron to provide even cooking. These elements hold heat longer than conventional type surface units. For best cooking results, use a HIGH setting for a very short period; then use a LOW setting to complete the cooking.
7. Using the Optional Cooking on the optional most the same as cooking There are three differences about: 1. The cookware you use. 2. What to expect. 3. The care and cleaning. Smoothtop Module smoothtop on surface you should IS alunits. know Cooking... The glass will take longer to heat up than a regular surface unit. It will also take longer to cool down. Turn off the unit a few minutes before you are finished cooking. l Do not use the smoothtop module for canning.
Changing cooktop modules The cooktop modules will work on either side of the cooktop. NOTE: The coil element on the right side of the RC8920XRH cooktor, is not removable. Coil Element, Solid Element and Smoothtop Modules NOTE: On the RC8920XRH 1. To remove, lift cooktop, slightly these optional 1. To replace, terminal receptacle With both hands, pull module toward you to unplug it 2. Push termynal Into place until it’s plugged In /i line up the with the will only fii in the left side. 2.
Grill Module NOTE: On the RC8920XRH cooktop, 1. To remove, Ilft off g,1lls 2. the grill module will Lift heating element slightly and pull toward only fit in the iett side. 3. Lift out splatter shreld 4. 3. PI ug heatIng element terminal Info receptacle 4. YOU 1. 2. To replace, lower the grease and Put In splatter shield pan the grease well into ooening. Ail grill parts must be cleaned after each fat spoilage and odors. See page 16. Optional The griddle 1.
Cleaning and caring for your cooktop Control Panel and Knobs 2. Pull control knobs straight off. 3. Use warm soapy water and a soft cloth, or spray glass cleaner, to wipe the control panel. Rinse and wipe dry. 4. Wash control knobs Rinse well and dry. in warm 5. Push control knobs straight sure they point to OFF. soapy back water. on.
Coil Elements and Reflector Bowls Replacing 1. Removing 2. Line up opening in the reflector coil element receptacle. bowl with the 3. Hold the coil element as level as possible with the terminal just started into the receptacle. 2. Lift the edge of the coil element opposite the receptacle just enough to clearthe reflector bowl. 4. While pushing the coil element terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. / 3. Pull the coil element receptacle. 4.
Solid Elements Its, wipe off solid elements with a damp soft cloth and soapy water after each use. Burned-on food may be removed with a soapy scouring pad. The red spot in the center of the solid elements will gradually wash off. This is normal and will not affect the operation of the surface unit. 2. IMPORTANT: After cleaning, apply a thin coat of salt-free oil to the CCCL solid elements, then heat 3-5 minutes. It may still smoke slightly when heated.
Cleaning Cooktop Chart PART WHAT TO USE HOW TO CLEAN Coil Element Module Heating Element Do not clean. l l Reflector Bowls Warm soapy water and plastic scouring pad or dishwasher. l l Soil burns off. Do not put in water. Wash, rinse and dry well. Do not use metal scouring harsh cleansers. pads or Wash, rinse and dry well. Do not use metal scouring harsh cleaners. pads or Grill Module ?!arm soapy water and plastic scouring pad l l Heating Element Do not clean.
PART WHAT TO USE HOW TO CLEAN Smoothtop Module Warm soapy water and a soft cloth or paper towel. Wash, rinse and dry well. Do not soak in water. To clean COOL cooktop: l For stubborn stains, soak paper towel with vinegar. Rub stained area. If needed, keep vinegar soaked paper towel on stain for IO-15 minutes. Rub off soil. l Rinse and dry well. l Do not use vinegar on metal parts. l For soils not removed with other methods, carefully scrape off the soiled area, then use the above cleaning method.
If you need service or assistance, we suggest you follow these five steps: 1. Before calling for assistance... Performance problems often result from little things you can find and fix yourself without tools of any kind. If nothing operates: Is the cooktop wired correctly to a live circuit with the proper voltage? (See Installation Instructions.
4. If you have a problem?. Call our COOL-LINE service assistance telephone number (see Step 2) and talk with one of our consultants, or if you prefer, write to: Mr. Donald Skinner Director of Customer Relations Whirlpool Corporation 2000 M-63 Benton Harbor, Ml 49022 5. Ifvou need FSP” replacement parts?.. FSP is a registered trademark of Whirlpool Corporation for quality parts. Look for this symbol of quality whenever you need a replacement part for your Whirlpool appliance.
WHIRLPOOL” RANGE PRODUCT WARRANTY LENGTH OF WARRANTY WHIRLPOOL FULL ONE-YEAR WARRANTY From Date of Purchase FSP’ replacement parts and repair laborto correct defects in materials or workmanship. Service must be provided by a franchised TECH-CARE” service company. WHIRLPOOL EROOl 1 WILL PAY FOR 1 WILL NOT PAY FOR A. Service calls to: 1. Correct the installation of the range product. 2. Instruct you how to use the range product. 3. Replace house fuses or correct house wiring or plumbing. 4.
