Instruction for Use

14
BEFORE USING THE APPLIANCE
•
Your new appliance is designed exclusively for domestic
use.
To ensure best use of your appliance, carefully read
the operating instructions which contain a
description of the appliance and advice on storing
and preserving food.
Keep this handbook for future reference.
1.
After unpacking the appliance, make sure it is not
damaged and that the door closes properly. Any damage
must be reported to the dealer within 24 hours of
delivery of the appliance.
2.
Wait at least two hours before switching the appliance on,
in order to ensure that the refrigerant circuit is fully
efficient.
3.
Make sure installation and the electrical connection are
carried out by a qualified technician according to the
manufacturer's instructions and in compliance with the
local safety regulations.
4.
Clean the inside of the appliance before using it.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packing material is 100% recyclable and bears the
recycling symbol. Comply with the local regulations for
disposal. Keep the packing materials (plastic bags,
polystyrene parts, etc.) out of the reach of children, as they
are a potential source of danger.
2. Scrapping/Disposal
The appliance is manufactured using recyclable material.
This appliance is marked in compliance with European
Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE).
By ensuring the correct scrapping of this appliance, you can
help prevent potentially negative consequences for the
environment and the health of persons.
The symbol on the appliance, or on the accompanying
documents, indicates that this appliance should not be treated
as domestic waste but must be taken to a suitable collection
centre for the recycling of electrical and electronic
equipment.
When scrapping the appliance, make it unusable by cutting
off the power cable and removing the doors and shelves so
that children cannot easily climb inside.
Scrap the appliance in compliance with local regulations on
waste disposal, taking it to a special collection centre; do
not leave the appliance unattended even for a few days,
since it is a potential source of danger for children. For
further information on the treatment, recovery and
recycling of this appliance, contact your competent local
office, the household waste collection service or the shop
where you purchased the appliance.
Information:
This appliance does not contain CFC (the refrigerant
circuit contains R134a) or HFC (the refrigerant circuit
contains R600a) (refer to the rating plate inside the
appliance).
Appliances with isobutane (R600a): Isobutane is a natural
gas without environmental impact but is flammable.
Therefore, make sure the refrigerant circuit pipes are not
damaged
Declaration of conformity
•
This appliance is intended for storing food and is
manufactured in conformity with European regulation
(EC) No. 1935/2004.
•
This product has been designed, manufactured and
marketed in compliance with:
- the safety objectives of Low Voltage Directive 73/23/
EEC;
- the protection requirements of “EMC” Directive 89/336/
EEC,
amended by Directive 93/68/EEC.
•
Electrical safety of the appliance is guaranteed only if it is
connected to an efficient and approved earthing system.
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
•
During installation, make sure the appliance does not
damage the power cable.
•
Make sure the appliance is not near a heat source.
•
To guarantee adequate ventilation, leave a space on
both sides and above the appliance and follow the
installation instructions.
•
Keep the appliance ventilation openings free.
•
Power cable modification or replacement must only be
carried out by qualified personnel.
•
It must be possible to disconnect the appliance from the
power supply by unplugging it or by means of a mains
two-pole switch installed upstream of the socket.
•
Make sure the voltage indicated on the appliance rating
plate corresponds to that of your home.
•
For the water connection, use the pipe supplied with
the new appliance; do not reuse that of the previous
appliance.
•
Install and level the appliance on a floor strong enough
to take its weight and in a place suitable for its size and
use.
•
The appliance must be handled and installed by two or
more persons.
•
Be careful not to damage the floors when moving the
appliance (e.g. parquet).
•
Do not use single/multi-adapters or extension cords.
•
Install the appliance in a dry and well-ventilated place.
The appliance is arranged for operation in places where
the temperature comes within the following ranges,
according to the climatic class given on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range.
•
Do not store or use petrol, gas or flammable liquids in
the vicinity of this or other electrical appliances. The
fumes can cause fires or explosions.
•
Do not use mechanical, electric or chemical means
other than those recommended by the Manufacturer to
speed up the defrost process.
•
Do not damage the appliance refrigerant circuit pipes.
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110