MODULAR COOKTOPS Models RCBBOOXL (3 Cooktop RC8300XL (2 Cooktop Modules) Modules) Control Panel Grill Module Reflector Bowl Number Plug-In Surface Unit Model RC83OOXL (Modules can be placed Surface Unit Model and Serlal Plate (Not Shown) in ony position.) Module Control Plug-In Surface One-Piece Chrome Reflector Bowl .
Your responsibilities.. . Installation and proper, safe use are your personal responsibilities. Read this “Use and Care Gulde” and the “Cooking Guide” carefully for Important use and safety Informatlon. Tou must be awe your cooktop Is... l installed and leveled In a countertop and cabinet that will hold the weight; a installed in a well-ventllated area protected from the weather; l properly connected to the correct electric supply and groundlng. (See “Installation Instructions.
Using your cooktop lnlt C nit/C Indlc It Slg RC88OOXL (3 Cooktop Modules) 4 RC83OOXL (2 Cooktop Modules)
SURFACE UNIT CONTROLS Control knobs must be pushed In before turnlng them to a setting. They can be set anywhere between HI to OFF. One ot the slgnal lights will glow when a surtaoe unlt is on. Be sure all lights are off when you are not cooklng. ting. Unt HI you get used to the settings, Use HI to start foods cooktng or to brlng llquids to a boll. Surface unlt will not turn red If good tontact Is made wtth use the followlng Use MED-HI to as a gulde.
For the Grlll Module, use front or back controls as you would for surface controls if you want both the front and back halves of the grill to heat. Grill on Left units. Use both Grill in the Center The Optlonal Black Smoothtop Center Rear : g : Center Front :I: Module Grill on the Right Right Rear works the same as Surface Unit Modules, CHANGING COOKTOP MODULES The Cooktop Modules will work on either side or the center of the cooktop.
1. To remove, off grill. 1. To replace, lower grease well into opening lift 2. Lift front end of heating element and pull toward you. 2. Put i.n basket with ceramic rot ks. All parts OPTIONAL GRIDDLE 1. To remove, lift and remove griddle cover. 3. Lift out basket of ceramic rocks. Plug heating element terminal into receptacle. must be cleaned after each use to avold spollage and odors. See page 14. (Model center MODULE 3. RC8800XL: The griddle ot the cooktop.) module 4.
OPTIONAL 1. BLACK SMOOTH- To remove, lift slightly by the handle. 2. With both hands, pull module toward you to unplug it 3. Lift out and set aside. 2. Push smoothtop into place until it’s plugged in. 3. Lower smoothtop into place. ReCeDtaCle 1. To replace, use both hands to line up the terminal with the receptacle. USING THE COOKTOP MODULES OPTIONAL GRIDDLE Before using the griddle for the first time: Wash, rinse and dry griddle. l Use warm sudsv water. l DO NOT immerse griddle.
GRILL MODULE A range hood should be used to help get rid of smoke while using the Grill Module (Whirlpool Model No’s RGH8330 or RGH8336 recommended for RC8300XL Cooktop; Model RGH8348 for the RC8800XL Cooktop). Approximate Preheat Grill Module grill for five minutes GRILL Cooklng limes at suggested setting. Wel htor Thlc p: ness Internal Temperature Control Setting(r) Approxlmate Cooklng Tlmo Slde 1 Slde 2 1 ” (2.
OPTIONAL Rotlsserle ROTISSERIE Parts The Rotisserie has 4 parts. It is used with the Grill Module. Tabs 1. Remove the grill from the Grill Module 2. Insert rear support tabs into slots at rear of the Grill Module. Ht$7’Posttlon 6. Slide back to lock Tilt top to level. 1. Put one fork on the spit pointing away from the handle. Push spit through meat so the weight IS balanced around the center Put the second fork on the spit pointing toward the meat.
Approximate Food rotlsserle cooklng tlmes: Internal Temperature Weight Control Setting(s) 140-F [ 60’C) 140-F (60-C) 3’2Ibs. Hi (I.5 kg) 3”4 Ibs. Hi (I.5 kg1 High 5Ibs. HI High 11~4”lbs. Hi High Y IL?! (1 kg1 Hi High 1 hr. 10 min. 5 Ibs Hi High 2 hr. 30 min. Hi High Hi High Hi High Hi High 1 hr. 45 min. 2 hr. 45 min. 2 hrs. 15 min. 2 hrs. Spit Posltlon Tlme Comments 1 hr. 55 min. 2 hr. Meat with an outer layer of fat may take longer to cook.
0 Wipe up any spill when the unit is cool enough not to steam when a wet cloth touches it. The longer you cook wlth a splllover on the unit, the harder It will be to remove that spill. 0 Clean off metal marks [from copper or aluminum] right away. If heated, they may never come off. CookIng.. The glass tilil take longerto heat up than a reglJk3r surtace unit. It Will alS0 take longer 1c7cool down Turn off the unit a few minutes before yolj are finished cooking. The Core and Cleaning...
Cleaning and caring for your cooktop CONTROL PANEL AND KNOBS SURFACE UNITS AND REFLECTOR BOWLS REMOVING 1. 2. First make sure knobs pull knob straight off. 1. Be sure surface 2. Lift the edge of the unit opposite the recep tacle just enough to clearthe reflector bowl. 3. Pull the surface recebtacle. are set on OFF then Use warm soapy water and a soft cloth to wipe the panel. Rinse and wipe dry. 4. 3. Wash knobs in warm well and dry. soapy water. Push the knobs straight they point to OFF.
5. Receptacle 3. Hold the surface unit as level as possible with the terminal just started into the receptacle. 4. While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl. Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills.
SMOOTHTOP l l MODULE Avoid Staining l See page 11 Use cleaner, conditioner often package directions carefully. l Follow If you do get a stain 1. A mildlv abrasive cleanser like Bar Keepers Friend’ with a plastic scouring pad will help remove stains that aren’tburned on. Use cleaner/conditioner afterwards 2. A soapy steel wool pad will help with stubborn spots Make sure the pad is very soapy. Use cleaner/conditioner afterwards 3. A moist sponge and automatic dishwasher detergent can help.
2 l APPLIANCES-HOUSEHOLDMAJOR-SERYICE & REPAIR Ifyou need assistance”‘. . . WHIRLPOOLAPPLIANCES FRANCHISEDTECHGARE Call the Whlrlpool COOL-LINE a‘ service assistance telephone number. Dial tree from: Continental U.S. . . . . . . . . (600) 253- 1301 Michigan . . . . . . . . . . . . . . . (800) 632-2243 Alaska 81Hawall.. . . . . . . (800) 253-1121 and talk with one of our trained Consultants.