Installation Instructions Quick Reference Table of Contents: Before you start Product dimensions Cabinet dimensions/requirements Electrical requirements Installation steps If range does not operate If you need assistance/service Moving the range If you need assistance: Check your Use and Care Guide for a toll-free number to call or call the dealer from whom you purchased this appliance.
Before you start... Product dimensions Important: Observe all governing codes ~——_ - and ordinances. width ———— 30" Proper installation is your responsibility. A qualified technician must install this range. Make sure you have everything necessary for correct installation. It is the installer’s responsibility to comply with installation clearances specified on the model/serial — rating plate. The model/serial rating plate is located on the oven frame behind the oven door.
Electrical requirements Power supply cord is not supplied, but is available through your local electrical supply house. Range must be connected to the proper electrical voltage and frequency as specified on the model/serial rating plate. (The model/serial rating plate is found on the oven frame behind the oven door.) A WARNING CONNECT WITH COPPER WIRE ONLY.
7 cow silver-colored terminal block ANI <7 Se 3 This appliance may be connected directly to the fuse disconnect or circuit breaker box; or with a U.L.-listed, 40-ampere range power supply cord (pigtail). Depending on your electrical supply, make the required three-wire or fe PLIPU Uy Rs i wy Direct wire method: Three-wire electrical connection: four-wire connection. line 2 | 1. Disconnect the power supply. TF 2.
Check that cooktop elements heat properly supply cord or power supply cable Check that oven heats properly Remove shipping material . ) Remove oven racks and parts package. J UJ Level range E leveling legs Operating position 1 O Move the range into final Operating ® position. Remove cardbo ard or hardboard from under range. Replace storage drawer or panei 1 2 if installing the range in a mobile ™ home, you MUST secure the range to the floor.
Check operation 4 ‘ LATCH OO @0o FRONT OFF BROL—e@ START ?—@ PREHEAT—@® CLEAN =e @ Ss DOOR DOOR © @ ON ahete: / <= 6 . 1 e LOCKED BAKE ff custom | AUTO fi temp BROIL START § OFF ons: \ ENTER ff CANCEL V ease y, If your oven has electronic control pads only (no timer): 1. Press the “BAKE” pad. 1 * The “BAKE” indicator and “350°F” will appear in the display. Check the operation of the cooktop = elements: Push in and turn each surface unit control knob to “HI” position.
If range does not operate: Moving the range: Check that the circuit breaker is not tripped or A.WARNING the house fuse blown. Check that the power supply cord is plugged into the wall receptacle. a) && See Use and Care Guide for troubleshooting list. If you need assistance: if you have questions about operating, cleaning or Injury Hazard Because of the weight and size of this range, two or more people are required to move it. Ail ranges can tip. Do Not step, lean or sit on the range drawer or door.
