www.whirlpool.com IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with homeowner. Homeowner: Keep Installation Instructions for future reference. Save: Installation Instructions for electrical inspector’s use. 24”, 30” and 36” Custom Series Range Hood Part No. 626788/883345 Rev.
Before you start... Your safety and the safety of others is very important. Product dimensions We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. ! This symbol alerts you to hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”.
Venting requirements Horizontal wall venting Now start... Vented models only With range hood in kitchen. Non-vented models cannot be converted to vent. Slide cardboard or hardboard under range before moving range across floor to prevent damaging floor covering. Cover countertop, cooktop or set-in range with a thick, protective covering to prevent damaging countertop. Venting outside. system must terminate Do not terminate the duct other enclosed space. Do not use four-inch caps.
\,I‘I ,I’1 I’, J,“11 centerline, W Determine and clearly mark a vertical centerline on the woli and cabinet in the area the vent opening will be mode. cabinet Mark 5-l/8” and 5-7/a” in from bock wall along the centerline on underside of cabinet. Use these points as centers to draw 7-l /8” circles on underside of cabinet. Use a sober saw to cut the openings for the ductwork. Repeat for the underside of the top of the cabinet. This will create slotted openings.
9 n Install duct throuah the vent opening in upper cabinet or wall. Complete venting system according to method needed. See “Venting requirements.” Use caulking to seal exterior wall or roof opening. Numbers corresoond to steyjs. 10V W If roof or wall cap does not have a damper, attach rectangular damper supplied with hood to selected rectangular vent opening. If damper is attached to back of range hood, be sure damper hinge is toward the top.
Use & Care Information If range hood does not operate... IOPERATION OF RANGE HOOD Check that the circuit breaker is not tripped or the house fuse blown. For best results, turn range hood fan on at beginning of cooking and allow it to run until all smoke and odors are removed from room. Electrical Shock Hazard Disconnect power before making electrical connections. Connect ground wire to green ground screw in terminal box. Failure to do so can result in death or electrical shock. If you need assistance.
Whirlpool” Range Hood Warranty LENGTH OF WARRANTY FULLONE-YEAR WARRANTY From date of purchase WHIRLPOOL WILL PAY FOR FSP@replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by an authorized WhirlpoolSM service company. WHIRLPOOL WILL NOT PAY FOR A. Any labor costs incidental to the replacement of defective parts. B. Consumable parts such as light bulbs and filters, C. Service calls to: 1, Correct the installation of the range hood. 2.