www,whirlpool,com IM PORTANT: Insfalmer: Leave Installation Instructions with homeowner, Homeowner: Keep Installation Instructions for future reference, Save Installation Instructions for electrical inspector's use, e Part No, 626869A/8284866 Rev, A
you sta o°° Your safety and the safety of ethers are very important, We have provided many important safety messagesin this manual and on your appiiance, Always read and obey all safety messages, J This is the safety aiert symbol, This symb0i alerts you to p0tentiai hazards that can kiii or hurt you and others, AIi safety messageswili f0ii0w the safety aiert symbol and either the word "DANGER"or "WARNING",These words mean: You can be killed or seri0usty injured if you don't f0110winstructions.
12, Venting system must terminate outside, t3, to the Do not terminate the vent in an attic or other enclosed space, Do not use four-inch laundry-type wall caps, Do not use plastic vent, Vent system needed for installation is not included, Backdraft damper supplied with product must be used. If roof or wall cap has a damper, do not use damper supplied with hood, Use metam vent onmy. Rigid metam vent is recommended. This range hood can be vented outside ONLY.
cabinet of tan e For best results, turn range hood fan ON at beginning of cooking and allow it to run until all smoke and odors are removed from room, write To turn fan ON and OFF: Press fan control to turn fan on and off and adjust fan speed, Speed may be increased or decreased anytime during range hood operation, To turn range hood light ON and OFF: Press light control to turn light on or off, Light may be turned off or on anytime during range hood operation, To vent through the roof or wall, mark 5-3
If ran e hood lfypu aSSIStanCe net operate°°° Check that the circuit breaker or the Rouse fuse blown, ooo Check your Use and Care Guide for o tollfree number to coil or col[ the dealer from whom you purchased this appliance, The dealer is listed in the Yellow Pages of your phone directory under "Appliances -Household -- Major -- Service and Repair", isnot tripped When you call, you will need the range hood mode[ number and serial number, Both numbers con be found on the model/serial rating plate loca