Ventilation Hood User Manual

VENTLESS KITCHEN RANGE HOOD

FOR 120 V. OPERATION

VENTLESS

INSTALLATION

KITCHEN

RANGE HOOD

MODEL

RH2600XL-1

SERIES

READ AND SAVE THESE INSTRUCTIONS

Before you begin, read the following instructions completely

and carefully. If followed, they will simplify the installation

job.

IMPORTANT: OBSERVE ALL GOVERNING CODES

AND ORDINANCES

SAVE THESE INSTRUCTIONS FOR THE LOCAL

ELECTRICAL INSPECTOR’S USE

Your range hood has been designed to filter out smoke,

odors and grease which rise from the cooking surface.

Before you begin the installation be sure that all parts and

accessories are removed from carton. For best results and

ease in the rnstallation of this range hood, read the

instructions sheet to become familiar with the step by step

installation.

Figure 1

TOOLS AND MATERIALS REQUIRED

Drill, electric or ratchet drive, with 1’55” wood bit (to drill an

access hole in the cabinet or kitchen wall for the electric

power line.)

One common head screwdriver (to secure hood mounting

screws to the cabinet and hood sheet metal parts).

Plrers (for opening knockouts)

Pencil, ruler and level for marking cabinet locations

Saber saw or keyhole saw for cutting the wall or cabinet

openings.

A626-66EW330871 A

Page 1

PAGE 1
VENTLESS KITCHEN RANGE HOOD FOR 120 V. OPERATION VENTLESS INSTALLATION KITCHEN RANGE HOOD MODEL RH2600XL-1 SERIES READ AND SAVE THESE INSTRUCTIONS Before you begin, read the following instructions completely and carefully. If followed, they will simplify the installation job.
PAGE 2
TO INSTALL For most efficient operation, top of hood approximately 66 (167.6 CM) inches from floor. 1. Mark locations grven in Figure 1. for electrical 2 Cut hole to accomodate minimize openings through These will have to be sealed 3. Run wire through National Electrical Code NOT turn power on until 4. Remove Frgure 2. screws wiring from should 5. Lrft the hood into each of the four keyhole box position and mark mounting slots. be Be sure to the ceiling.
PAGE 3
OPERATION COMBINATION AND IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES and when it are no effec- When should LIGHTS: 1. Do not use bulb larger CARE OF EXTERIOR than 60 watts in light socket. Fan motor has life time sealed bearings that never need oiling under normal usage. A few drops on each bearing after three years of heavy usage will prolong the motor life. Clean motor with a damp cloth and grease cutting detergent when a heavy coating of grease has accumulated.